S Digital TT-9311-BTM3EJ User Manual

OPERATING INSTRUCTIONS

MP3

DIGITAL

PLAYBACK

LEATHERETTE BRIEFCASE

TURNTABLE

MODEL : TT-9311-BTM3EJ

USB

FLASH MEMORY
MP3 PLAYBACK

WARNING:

- TO PERVENT FIRE OR SHOCK HAZARD,DO NTO EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.

- TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER.

IMPORTANT SAFETY INSTRUCTIONS

1.READ INSTRUCTIONS-AII THE SAFETY AND OPERATING INSTRUCTIONS
SHOULD BE READ BEFORE THE APPLIANCE IS OPERATED.

2.RETAIN INSTRUCTIONS-THE SAFETY AND OPERATING INSTRUCTIONS
SHOULD BE RETAINED FOR FUTURE REFERENCE.

3.HEED WARNIGS-ALL WARNINGS ON THE APPLIANCE AND IN THE
OPERATING INSTRUCTIONS SHOULD BE ADHERED TO.

4.FOLLOW INSTRUCTIONS-ALL OPERATION AND USE INSTRUCTIONS
SHOULD BE FOLLOWED.

5.WATER AND MOISTURE - THE APPLIANCE SHOULD NOT BE USED
NEAR WATER;FOR EXAMPLE NEAR A BATHTUB, WASHBOWL,KITCHEN
SINK,LAUNDRY TUB,IN A WET BASEMENT OR NEAR A SWIMMING POOL
AND THE LIKE.

6.CARTS AND STANDS - THE APPLIANCE SHOULD BE USED ONLY WITH
A CART OR STAND THAT IS RECOMMENDED BY THE MANUFACTURER.
AN APPLIANCE AND CART COMBINATION SHOULD BE MOVED WITH
CARE. QUICK STOPS,EXCESSIVE FORCE AND UNEVEN SURFACES
MAY CAUSE THE APPLIANCE AND CART COMBINATION TO OVERTURN.

7.WALL AND CEILING MOUNTING - THE APPLIANCE SHOULD BE MOUNTED
TO A WALL OR CEILING ONLY AS RECOMMENDED BY THE MANUFACTURER.

8.VENTILATION - THE APPLIANCE SHOULD BE SITUATED SO THAT IS
LOCATION OR POSITION DOES NOT INTERFERE WITH ITS PROPER V
ENTILATION . FOR EXAMPLE, THE APPLIANCE SHOULD NOT BE SITUATED
ON A BED, SOFA, RUG OR SIMILAR SURFACE THE MAY BLOCK THE
VENTILATION OPENINGS;OR PLACED IN A BUILT - IN INSTALLATION SUCH
AS A BOOKCASE OR CABINET THAT MAY IMPEDE THE FLOW OF AIR
THROUGH THE VENTILATION OPENINGS.

9.HEAT - THE APPLIANCE SHOULD BE SITUATED AWAY FROM HEAT SOURCES
SUCH AS RADIATORS, HEAT REGISTERS, STOVES OR OTHER APPLIANCES
(INCLUDING AMPLIFIERS)THAT PRODUCE AWAY FROM HEAT.

10.POWER SOURCES - THE APPLIANCE SHOULD BE CONNECTED TO A POWER
SUPPLY ONLY OF THE TYPE DESCRIBED IN THE OPERATING INSTRUCTIONS
OR AS MARKED ON THE APPLIANCE.

11.GROUNDING OR POLARIZATION - PRECAUTIONS SHOULD BE TAKEN SO
THAT THE GROUNDING OR POLARIZATION MEANS OF AN APPLIANCE IS
NOT DEFEATED.

12.POWER - CORD PROTECTION - POWER SUPPLY CORDS SHOULD BE
ROUTED SO THAT THEY ARE NOT LIKELY TO BE WALKED ON OR PINCHED
BY ITEMS PLACED UPON OR AGAINST THEM, PAYING PARTICULAR
ATTENTION TO CORDS AT PLUGS, CONVENIENCE RECEPTACLES AND THE
POINT WHERE THEY EXIT FROM THE APPLIANCE.

E-2

13.PROTECTIVE ATTACHMENT PLUG - THE APPLIANCE IS EQUIPPED WITH AN
ATTACHMENT PLUG HAVING OVERLOAD PROTECTION. THIS IS A SAFETY
FEATURE. SEE INSTRUCTION MANUAL FOR REPLACEMENT OR RESETTING
OF PROTECTIVE DEVICE.IF REPLACEMENT OF THE HAS THE SAME
OVERLOAD PROTECTION AS THE ORIGINAL PLUG.

14.CLEANING - THE APPLIANCE SHOULD BE CLEANED ONLY AS RECOMMENDED
BY THE MANUFACTURER.

15.POWER LINES - AN OUTDOOR ANTENNA SHOULD BE LOCATED AWAY FROM
POWER LINES.

16.OUTDOOR ANTENNA GROUNDING - IF AN OUTSIDE ANTENNA IS CONNECTED
TO THE RECEIVER,BE SURE THE ANTENNA SYSTEM IS GROUNDED SO AS TO
PROVIDE SOME PROTECTION AGAINST VOLTAGE SURGES AND BUILT UP
STATIC CHARGES.

17.NONUSE PERIODS - THE POWER CORD OF THE APPLIANCE SHOULD BE
UNPLUGGED FROM THE OUTLET WHEN LEFT UNUSED FOR A LONG PERIOD
OF TIME.

18.OBJECT AND LIQUID ENTRY - CARE SHOULD BE TAKEN SO THAT OBJECTS
DO NOT FALL AND LIQUIDS ARE NOT SPILLED INTO THE ENCLOSURE
THROUGH OPENINGS.

19.DAMAGE REQUIRING SERVICE - THE APPLIANCE SHOULD BE SERVICED BY
QUALIFIED SERVICE PERSONNEL WHEN:
A. THE POWER SUPPLY CORD OR THE PLUG HAS BEEN DAMAGED OR
B. OBJECTS HAVE FALLEN OR LIQUID HAS BEEN SPILLED INTO THE
APPLIANCE OR
C. THE APPLIANCE HAS BEEN EXPOSED TO RAIN OR
D. THE APPLIANCE DOSE NOT APPEAR TO OPERATE NORMALLY OR EXHIBITS
A MARKED CHANGE IN PERFORMANCE OR
E. THE APPLIANCE HAS BEEN DROPPED OR THE ENCLOSURE DAMAGED

20.SERVICING - THE USER SHOULD NOT ATTEMPT TO SERVICE THE APPLIANCE
BEYOND THAT DESCRIBED IN THE OPERATING INSTRUCTIONS. ALL OTHER
SERVICING SHOULD BE REFERRED TO QUALIFIED SERVICE PERSONNEL.

The device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the product.
NOTE: This product has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This product generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If the product does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures
: -Reorient or relocate the receiving antenna. -Increase the separation between the product and receiver. ­Connect the product into an outlet on a circuit different from that to which the receiver is connected. ­Consult the dealer or an experienced radio/TV technician for help.

Phonograp h Li d
support Br ack et

Speaker

VOLUME
Control

FRON T PANEL

USB PLAYER

Indicator

STAN DBY /ON

Indicator

USB-MP3

PLAYER B utt on

STAN DBY /ON

Butto n

PHONO-REC

Button

LOCATION OF CONTROLS

Phonograp h Li d

Handle

USB Socket

Latch

Speaker

PHONO P LAYE R/
REC Indica tor

BT I ndi cat or

PHONO P LAYE R
Button

BT B utt on

E-3

E-4

TURNTABLE PANEL

TRANSIT SC REW
CROSSING

LIFT LE VER

TON E ARM LOC K

SPEED SELE CTOR
(33/45/78 RPM )

UNPACKING AND SET UP

- CA REFULLY REMO VE THE UNIT FROM THE DISPLAY C ARTON AND REMOVE
ALL PACKING MATERI AL FRO M THE UNIT.

- UN WIND THE AC AD APTOR JACK CABLE AND EXTEND IT TO I TS FU LL LEN GTH.

- PL ACE THE UNI T ON A STAB LE, L EVEL SURFACE , CONVENIE NT TO AN AC
OU TLET OUT OF A S TRONG MAGN ETIC FIELD.

- CO NNECT THE AC ADAPTOR PLUG TO YOU R AC OU TLET.

- RE MOVE THE OPAQUE WH ITE P LASTIC STYLUS
CO VER F ROM TH E PHO NOGRAPH STYLUS BY
SL IDING IT IN THE D IRECTION O F THE ARROW.

- DU RING THIS O PERATI ON PAY ATTENT ION TO THE STYLUS , BEC AUSE T HE
ST YLUS DAMAGE IS NOT CO VERED BY GU ARANTEE.

- RE MOVE THE TW IST-TI E THAT WAS USED TO SECURE T HE TON E ARM
DU RING THE SH IPME NT.

- RE LEASE THE TO NE ARM LOCK LEVEL.

VOLUME

CONTROL

BACK PANEL

HEADPHONE

3.5mm AUX-I N Ja ck

TURNTAB LE 45 RPM

ADAPTO R

LINE OU T R

E-5

LINE OU T L

TON E ARM WIT H
STYLUS

DC INPUT So cket

POWERING ON THE UNIT

- CO NNECT THE AC ADAPTE R TO TH E DC I NPUT SOCKE T ON TH E BAC K OF
TH E UNIT. TH EN THE STANDBY/ON INDICATOR WI LL LIG HT ON, NOW T HE
UN IT ON "STANDBY" MODE.

- PR ESS S TANDBY /ON BUTTON. THE D ESIRED PLAYI NG SO URCE INDIC ATOR
WI LL LIG HT ON.

- WH EN YOU HAVE F INISHED US ING THE SYS TEM, PRESS STANDBY/ON BUTTO N
AGA IN, TU RN OF F THE UNIT W ITH V OICE MESSA GE: P OWER OFF.

E-6