Instructions
for the installation of the bin top kit, KBT29 onto bin B842
Applications: 30” wide cuber, centered or positioned left or
positioned right.
1. Uncrate the bin.
2. Install the legs.
3. Open up KBT29 kit, it will contain two filler plates with insulation attached, one large
filler plate without insulation, one insulation pad, four mounting straps, mounting
hardware and a tube of food grade RTV sealant.
Mounting
Straps
Small Filler
Small Filler
Plate
Plate
RTV Sealant
Large Filler
Plate
17-3003-01 Rev A
Centered Ice Machine:
a. Place a filler plate on each end of the bin
b. Secure each at the back with one 5/16” bolt from the kit.
c. Drill three 1/8” dia holes thru the bin’s outside panel using the holes in the flange of
each filler plate as a template. Do NOT drill beyond the outside panel.
d. Attach the side of each filler plate to the bin with three #8 sheet metal screws from
the kit.
e. Place ice machine centered between the two filler plates.
f. Secure ice machine to the bin with the two medium length straps from the kit and the
bolts from the ice machine’s hardware bag.
g. Seal the edges of the ice machine to the filler plates with the RTV sealant.
Ice Machine Positioned Left
a. Place gasket pad on bottom of large filler plate, be sure gasket pad is to the left end
of the plate. See last page of these instructions.
b. Place ice machine onto bin all the way to the left
edge.
c. Place filler plate onto bin next to the ice machine.
d. Secure at the back with one 5/16” bolt from the kit.
e. Drill three 1/8” dia holes thru the bin’s outside panel
using the holes in the flange of each filler plate as a
template. Do NOT drill beyond the outside panel.
f. Attach the side of each filler plate to the bin with
three #8 sheet metal screws from the kit.
g. Secure ice machine to bin using one short strap and one long strap.
h. Seal the edges of the ice machine to the filler plate with the RTV sealant.
Ice Machine Positioned Right
a. Place gasket pad on bottom of large filler plate, be sure gasket pad is to the right end
of the plate. See last page of these instructions.
b. Place ice machine onto bin all the way to the right
edge.
c. Place filler plate onto bin next to the ice machine.
d. Secure at the back with one 5/16” bolt from the kit.
e. Drill three 1/8” dia holes thru the bin’s outside panel
using the holes in the flange of each filler plate as a
template. Do NOT drill beyond the outside panel.
f. Attach the side of each filler plate to the bin with
three #8 sheet metal screws from the kit.
g. Secure ice machine to bin using one short strap and
one long strap.
h. Seal the edges of the ice machine to the filler plate with the RTV sealant.
Insulation Material
Line Up
Insulation
With Side
Flange
Side View of
Filler Plate
Position Insulation
Here If Filler Plate
Will Be On The
Right End Of The
Bin
Bottom
View of
Filler Plate
Insulation Material
Filler Plate and Insulation Pad Diagram
Position Insulation
Here If Filler Plate
Will Be On The Left
End Of The Bin
Loading...