HDSWC1
HANDLE BAR CONTROL INTERFACE
FOR 1998-2013 HARLEY DAVIDSON
MOTORCYCLES
This HDSWC1 interface allows you to replace your factory original Harley Davidson
stereo while retaining handle bar mounted controls (when equipped). The interface is
designed for easy plug and play connection and NO cutting, splicing or adding addtional
resistors is required. The included harness also provides +12V Constant power, +12V
Switched power and Front speaker connections.
APPLICATION GUIDE
HARLEY DAVIDSON:
ROAD GLIDE/FLTR 1998-2013
STREET GLIDE/FLHX/FLHT 1998-2013
FEATURES
-Retains handle bar contol controls (If equipped)
-Retains OEM phone buttons (if aftermarket stereo supports)
LIABILITY DISCLAIMER
This HDSWC1 instruction manual is based on carefully documented data and research. Scosche
Industries Inc. cannot be held responsible for discrepancies/inconsistencies that may occur due
to the vehicle manufacturing changes or options, or damages that may occur in the vehicle during
the installation of components while using this manual.
If you any further questions, call our toll-free techincal help line at: 1-800-621-3695 x3
© Scosche Ind. Inc. 2014 3000HDSWC1 Rev2 10_2014
1
/Pioneer
Cut Blue and Green loops
HDSWC1 WIRING DIAGRAM
Alpine
Cut Green wire loop
Clarion
Cut Violet wire loop
JVC
Cut Green AND Violet loops
Panasonic
Cut Blue wire loop
Kenwood / JVC 2011 & later
Sony
Do NOT cut loops
1
C
W
S
S
AFTERMARKET
RADIO
Blue/Yellow wire steering wheel
output (JVC, Kenwood)
3.5mm steering wheel
output (Alpine, Clarion, Panasonic, JVC, Sony)
Violet loop
Green loop
Blue loop
12-pin
Plug
only!
1CWSDH
14-pin
Plug
HDSWC1
ssenrah ekiB oT <
Configure steering harness for Aftermarket
stereo using chart below:
only!
Cut Blue AND Green loops
/Pioneer
4
Loading...