CR1284
IN-DASH INSTALLATION KIT FOR
2004 CHRYSLER PACIFICA
LIABILITY DISCLAIMER
This instruction booklet is based on carefully documented data and research of automobile dash
disassembly, wire harness/codes and information per taining to installation of this kit (CR1284) in
2004 Chrysler Pacifica Vehicles. Scosche Industries, Inc. can not be held responsible for
discrepancies/inconsistencies that may occur due to the automobile manufacturing changes or
options, or damage that may occur in the automobile during the installation of components while
using this booklet.
5495
TRIM RING
5404 POCKET
5464
MOUNTING PANEL
5403-1
REAR
SUPPORT
Thank you for purchasing the Scosche HA1569 Kit. This kit was manufactured with the highest of quality
standards.
CAUTION:
DISCONNECT YOUR VEHICLE'S NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLATION TO HELP PREVENT ELECTRICAL DAMAGE. WE RECOMMEND THE USE OF A VOLT/
OHM METER OVER A TEST LIGHT TO CHECK WIRING. A TEST LIGHT OR GROUNDED WIRE
PROBE CAN CAUSE DAMAGE TO THE VEHICLE'S COMPUTER AND/OR DIAGNOSTIC
SYSTEMS. AVOID ALL FACTORY AIR BAG WIRING - AIR BAGS CAN ACCIDENTALLY DEPLOY
CAUSING SERIOUS INJURY OR DEATH.
NOTES:
• See your vehicle's instructions for any special tools your installation might require.
• Read all instructions accompanying your car stereo/cassette player for proper wiring and mounting
instructions.
INTRODUCTION / PRELIMINARY
A. ATTACHING THE REAR
BRACKET:
Align the two (2) screw
emboss locations to the
matching locations on
pocket. When aligned, slide
the bracket together. Screw
the two (2) supplied screws
to screw emboss locations
B. ATTACHING THE POCKET:
Align the pocket to the snaps
of kit panel. Snap the pocket
into place on the back of kit
panel.
RADIO REMOVAL
1. Move shifter into drive position.
2. Using Allen key, remove screw from front of shifter. Remove shifter.
3. Using panel removal tool, pop out shifter bezel. Disconnect and remove.
4. Using panel removal tool, pop out the key switch surrounding ring.
5. Using panel removal tool, pop out side trims that extend on the left and right side of radio and AC
controls.
6. Extract four (4) Phillip head screws from radio, disconnect and remove.
5464 KIT PANEL
VARIOUS
REAR SUPPORT
BRACKET
DIN
MOUNT
RADIO
5464
MOUNTING PANEL
5404 POCKET
5403-1 REAR SUPPORT
POCKET ASSEMBLY
STEREO INSTALLATION
MOUNTING THE RADIO
CAUTION:
REAR SUPPORTING THE
RADIO ADDS TO THE
INSTALLATIONS
STRUCTURAL INTEGRITY.
RADIO’S
MOUNTING
SLEEVE
BEND TABS
OUTWARD
NOTE: Before mounting the CR1284 Kit Panel to the factory dash, you must custom modify the
dash cavity. Located on the bottom area of the dash cavity is a pair of plastic rear supports. You
must cut/remove the rear supports to ensure the kit panel’s pocket will not interfere with the dash
cavity. If you do not cut/remove, the kit panel will not fit.
Loading...