Scitec H2000,H2000-VRI User Manual

H2000 and H2000VRI

Telephone User Guide

Unpacking your phone

This package should contain the following:

• Telephone base unit

• Telephone handset unit

• Coiled handset cord

• Straight line cord

Installation

The H2000 and H2000-VRI telephones are designed for use behind a
registered PBX system. The telephone user or system installer must
supply an RJ-11 modular wall jack to connect this telephone to the PBX
system. The PBX “station port” type must be “Industry Standard
Analog” or “POTS.” This telephone cannot be used with “digital” PBX
station ports.

Insert one end of the coiled handset cord into the jack on the BOTTOM
END of the base unit. Insert the other end of the cord into the jack on
the BOTTOM END of the handset. The handset of the unit should now
be placed into the base of the unit. Connect the straight line cord from
the wall jack to one of the line jack located underneath the base unit.

Lift the handset. A dial tone should be heard in the receiver.

Explanation of Controls

(1) Ringer Volume – Adjusts ringer volume to LOW or HI. Located on

the left side of the phone near the dataport.

(2) Hearing-aid Compatible Handset

(3) Handset Jack – Modular jack to connect coiled handset cord from

handset to base unit.

(4) Data Port – Provides access to the telephone line for optional

connection of modem, fax, or answering machine. Located on
the left side of the phone near the ringer control.

(5) Dialing Keys – 0 – 9 dialing keys.

(6) VOL switch – Volume control switch on the handset steps through

the three available handset volume levels [Normal – Medium –
High].

(7) Visual ringing indicator – Indicates phone is ringing or a message

is waiting. Responds to NEON/90V message waiting light
format. (H2001-VRI model only)

Using the H2000 ad H2000-VRI telephones:

To place a call: Lift the handset, then dial the number desired.

To answer a call: Lift the handset.

Adjusting Handset Volume

Press the [VOL] key. Each press of [VOL] moves to the next of three
possible settings of [Low – Medium –High], and repeats back to Low
volume on the forth press. Adjust as desired.

Adjusting Ringer Volume

The ringer volume control switch is located on the left side of the
telephone. There are two ringer volume settings, high and low. Adjust
as desired.

Required FCC Notice

This equipment complies with Part 68 of the FCC rules and the
requirements adopted by the ACTA. On the bottom of this equipment is
a label that contains, among other information, a product identifier in the
format US:AAAEQ##TXXXX. If requested, this number must be
provided to the telephone company.