Scientech Electronics RC3N User Manual

REMOTE CONTROLLER

INTRODUCTION

RC-3 is a remote controller, which controls LS-30 Base Unit remotely. Thanks to
using hopping-code technology, it is highly secure.
There are four buttons on RC-3, as shown below

Away

Panic

Disarm: To disarm the system.
Away: To arm the system.
Home: To arm the system partially. Burglar sensors with Inactive Home

Mode attribute are disabled.

Panic: To activate panic alarm.

INSTALLATION

Select “Installer Mode” on the Base Unit, and enter Installer Password to gain
access authority. Then select \Set Device\Enroll Device\Controller\Enter Zone No.
to enroll the ID of RC-3 by pressing its DISARM button. You may change its
various attributes under \Set Device\Change Device Setting\Controller Change, to
fulfill different requirements.

Remarks: If an RC-3 is set with Latchkey attribute ON, the Base Unit will call

“Latchkey Number” (refer to section 4-2-1) whenever the Disarm or
Away button is pressed.

SPECIFICATIONS:

Buttons: 4
Radio Code: hopping, with 7.3 X 10
Battery: CR2032 button cell, 3V
Estimated Battery Life: 4 years (@actuated 4 times / day)
Size: 40.5 x 55.0 x 12.7 mm
Weight (w/ battery, w/o key ring): about 18g

19

combinations.

Disarm

Home

Manual-BackCover.jpg (2544x3685x16M jpeg)