Schweigen PKEV-6UCQS1, PKEV-6UCQST, PKEV-9UCQS1, PKEV-9UCQST Installation and Operation Guide
RANGEHOOD & INSTALLATION GUIDE
EV-6UCQ
EV-9UCQ
www.schweigen.com.auRevision V2_161219
Index
1. Before Installation 3
Important Information 3
2. Maintenance & Service 4
Led Bulb Replacement 5
Electrical Cord 5
For Users 5
3. Description 6
Rangehood Contents 6
Operation 6
Cutout Size 6
4. Installation 7
Rangehood Size Vs Cooktop Size 7
Overhead Cabinet Rangehood Installation Position 7
Recommended Installation Height For Induction Cooktop 8
Mounting Points 9
Overview 10
5. Condensation Information 11
6. Troubleshooting 12
7. Service 13
8. Specications 14
Dimensions 14
Technical Specications 14
9. Disclaimer 15
Page 2
1. Before Installation
Important
• Please read this section thoroughly before attempting to install or operate the rangehood. Inspect
your product upon receipt. Any damage or defects MUST be reported within 48 hours, or no claim
will be recognised.
• Before installing the electrical connections, you should:
– Verify that the indicated electrical data coincide with the voltage values and frequency of the
electrical circuit in the house where the rangehood is to be installed;
– Check that the premises has electrical protection against short circuits and electrocution, pursuant
to the applicable legislation;
– Always switch o the current using the double-pole switch before maintenance and turn the power
on again for normal use only when the operation has been completed.
• DO NOT INSTALL THIS APPLIANCE IF YOU FIND IT DAMAGED.
• If this product is installed damaged, neither the supplier, nor the retailer, will be responsible for the
costs associated with the repair, replacement, removal or re-installation of the appliances.
• Please read the entire instructions before installing the rangehood, always switch power o prior to
installation. All electrical work must be done by a registered electrician in accordance with local and
national electrical codes as applicable. For your safety, this product must be earthed.
• The power socket must be accessible and enable the end user to isolate the rangehood from the
power for the purpose of internal cleaning or maintenance.
• Check the contents of the packaging, check all electrical functions of the canopy before installation.
Canopy is heavy. Please ensure adequate care when installing to prevent personal injury.
• A power outlet should be within reach of the power cord exit from the rangehood.
• The canopy hood is not intended for use by persons (including children) with reduced physical, sensory
or metal capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• There must be adequate ventilation of the room when the rangehood is used at the same time as
appliances burning gas or other fuels.
• There is a re risk if cleaning is not carried out in accordance with the instructions. You must read the
details concerning the method and frequency of cleaning.
• Do not ambé under the rangehood. This will void the warranty.
• Exhaust air must not be discharged into an existing ue which is used for exhausting fumes from
appliances burning gas or other fuels.
• The minimum distance between the hob surface and the lowest part of the rangehood is 650mm. This
distance shall be at least 650mm, if the rangehood is installed over a gas hob. If the instructions for the
gas hob specify a greater distance, this has to be taken into account.
• Attention should be given to ensure that any applicable regulations concerning the discharge of
exhaust air is fullled. Even a partial obstruction will restrict the eciency of the rangehood.
• Stainless steel is very easily damaged during installation if abraded or knocked by tools. Protect the
rangehood with the cardboard box or plastic bag during installation.
Page 3
2. Maintenance & Service
• CAUTION: Accessible parts may become hot when used with cooking appliances.
• We recommend this appliance be installed and repaired by a qualied technician.
• It is dangerous to modify any part of this appliance. Modication of any kind, will immediately void the
warranty.
• The manufacturer declines all responsibility in case of failure to adopt proper safety measures.
• Please consult local laws and regulations and install in accordance.
• Use an electrical connector with earth that is correct for your location.
• Check that the voltage in your area corresponds to the appliance as indicated on the rating label.
• This appliance must be connected to an electricity supply with a ground connection.
• Check that the installation and electrical connections are made by a qualied technician and that the
indicated instructions and local regulations in force are met, using materials that are compliant with the
applicable legislation.
• The company will not be responsible for installations executed by non-qualied persons and
installations that fail to heed the applicable legislation on electrical safety (with regard to both modes
and materials).
• The electrical technical data can be found inside the rangehood, after removing the grease lters.
• The exible power cable supplied is already connected internally and emerges from the rangehood
near the air outlet tube.
Maintenance and Service
• Always switch o and disconnect power before cleaning.
• The rangehood surface should be cleaned with soft cloth and non-corrosive detergent. Wash with
warm soapy water and a soft sponge. Never use abrasive detergent, scouring pads, steel wool or
solvents on any part of this appliance, Always make sure to dry the appliance after cleaning and never
leave wet, as this will cause irreparable damage.
• Clean the interior of the rangehood with a damp cloth and a neutral detergent or denatured alcohol.
• For better results, you can use high quality cleaning and protection products (e.g. Steel Kleen) to clean
rangehood.
• Do not leave the rangehood surface wet after cleaning.
• Particular care must be taken with the aluminium lters which must be periodically cleaned (at least
every month, this will vary depending on frequency of cooking and type of foods cooked). Remove
the grease lters and wash them either by hand using hot soapy water or in the dishwasher using
mild detergent. Do not scrub. Note - some discolouration of the frame may occur when washing in the
dishwasher Caution: Never use abrasive or oil based liquid cleaners.
• If the grease lters are very dirty, the motor will extract only a small quantity of air, which reduces
its eciency. The grease deposits that build up on the lter are highly ammable and COULD EASILY
CATCH FIRE. The manufacturer is exonerated from all responsibility in the event of re due to poor
maintenance of the grease lters.
• Important: Never attempt to repair this appliance by yourself. Always refer to a qualied Service
Technician. Remember to always switch o the electricity and unplug the connection before
conducting maintenance or cleaning.
Page 4
2. Maintenance & Service
5
Incandescent Bulb Replacement
• Switch o the power to the canopy hood and allow the bulb to cool.
• Remove the bulb by turning it by hand in an anti clockwise direction
• Care must be taken to avoid the bulb falling onto the hob top
• Replace the bulb by inserting it into the socket and hand turning
in a clockwise direction
Electrical Cord
Ensure the supply cord is not exposed to heat, chemicals or sharp objects. If the supply cord is damaged,
it must be replaced by the manufacturer, service agent or a similarly qualied person in order to avoid
a hazard.
For Users
• This product is designed for household use and should not be used outside or for commercial
applications. After use, always ensure that all controls are in the “OFF” position. When frying with
a gas ame, take particular care not to allow the oil or grease in the pan to catch re. (Flambé)
• Do not leave the frying pan or fryer unattended, as the oil could overheat and catch re.
• Never ambé any foods beneath the rangehood. The ames could cause a re.
• Before carrying out any operation inside the rangehood, unplug the appliance from the electrical
mains.
• Respect the cleaning frequencies and intervals for changing the lters, as otherwise the accumulated
grease could cause a re or damage the product.
• Changes made to the steel surface will render the warranty invalid.
Page 5
Loading...