Schrader Electronics PTPMS14 User Manual
The device under test is manufactured by the grantee (Schrader Electronics) and sold as an
OEM product. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must ensure
the end-user has all applicable / appropriate operating instructions. When end-user instructions
are required, as in the case of this product, the grantee must notify the OEM to notify the enduser.
Schrader Electronics will supply this document to the reseller/distributor dictating what must
be included in the end user’s manual for the commercial product.
INFORMATION TO BE INCLUDED IN THE END USER'S MANUAL
The following information (in blue) must be included in the end product user’s manual to
ensure continued FCC and Industry Canada regulatory compliance. The ID numbers must
be included in the manual if the device label is not readily accessible to the end user. The
compliance paragraphs below must be included in the user's manual.
******************************************************************************
FCC ID: MRXPTPMS14 IC: 2546A-PTPMS14
This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
WARNING: This device has been designed to operate with Schrader tire stem PN: 20522054 or
PN: 20522091R01 only, as provided by the manufacturer. Alternative tire stems are strictly
prohibited for use with this device. Changes or modifications not expressively approved by the
party responsible for compliance could void the user's authority to operate the equipment. The
term “IC:” before the radio certification number only signifies that Industry Canada technical
specifications were met.
******************************************************************************
Loading...