Scholz Research & Development Rockman Ultimatum Distortion Generator Operating Manual
ROCKMAN
ROCKMANROCKMAN
ROCKMAN
ULTIMATUM
ULTIMATUM
ULTIMATUMULTIMATUM
DISTORTION
DISTORTION GENERATOR
DISTORTION DISTORTION
OPERATING MANUAL
GENERATOR
GENERATORGENERATOR
to the Rockman° Ultimatum Distortion Generator Pedal'". It was
emulate the sound of amplifier
saturation compression. This sophisticated
Generator is with
Connect
of your amp. Set the
The easiest method to get good sound is to set your amp to a clean or rhythm
also use the "dirty" channel or a
you want the maximum amount of sustain or
Compression
If you're using an amp that is
turn the Gain knob down to avoid feedback.
tar and your amp
ing your guitar
tars with single coil or humbucker
This warranty does not extend to any damage caused by misuse,
related damages, or use
oduct. This warranty
gives you specific legal rights, and you may also have other rights which
ROCKMAN
ROCKMAN
ROCKMANROCKMAN
Welcome
designed to be used with an electric guitar to
output tube distortion and tape
processor is very easy to use in a wide variety of situations.
The most common application for the Ultimatum Distortion
an electric guitar and a standard guitar amp:
Connect a guitar cord from your guitar to the Input of the Pedal.
another cord from the Output of the Pedal to the input
Pedal controls at 5 and play.
channel setting and turn on the Pedal. You can
distortion setting on your amp if
feedback.
The Volume knob controls the overall output level.
The Treble knob controls high treble frequencies.
The Bass knob controls low bass frequencies.
The G ai n kn o b co ntr o l s th e am ount o f Tape Sa turation
available for smooth sustain and even dynamics.
set fairly loud you may need to
This will reduce noise, too.
Please feel free to try different settings on the Pedal, your gui
to get the sound you're after.
You can use the Distortion Generator as a preamp for record
direct to tape. This works well with electric gui
style pickups.
The Ultimatum Distortion Generator requires two 9 volt batteries or the
optiona l S R & D Ac e Po w er S u p pl y . B at t er i e s ar e accessed
through the bottom plate by removing the two screws at the rear of the
unit. (under the Input and Output jacks)
One Year Limited Warranty
Return enclosed registration card to activate your unit for warranty.
Scholz Research and Development, Inc. (SR&D) takes pride in the fact
that no SR&D products leave our factory without being quality tested
to give you carefree use. SR&D warrants your product to be free of
manufacturing defects for a period of one (1) year from the original
date of consumer purchase. If this product should become defective
within the warranty period, SR&D will elect to repair or replace it, free of
charge. Should you experience a probl em with your product ,
please send it to our service center as described below.
TO OBTAIN WARRANTY SERVICE IN THE UNITED STATES:
1. Ship this product with all transportation and insurance charges prepaid
to the SR&D Service 1560 Trapelo Rd. Waltham, MA 02154.
For protection, shipment in the original packaging is recommended.
2. For expediency, a letter explaining the problem and any other
pertinent information should be included. Be sure to include your return
address. 3. If you have any questions about service, please call the
Service Center at 617-890-5211.
accident, improper installation, weatherÂcontrary to the instructions furnished with the pr
vary from state to state.
This warranty is valid only in the United States. For service on products
purchased outside the U.S. contact the place of purchase for service
address.
Loading...