Schneider Electric 100BASE-TX, 100BASE-FX User Manual

The media converter Ethernet transceiver 100 Mbps TX/FX enables media transition from 100BASE-TX (twisted pair cabling) to 100BASEFX (fiber optic).

The module conforms to the specifications of IEEE 802.3 respectively ISO/IEC 8802-3.

The media converter has a twisted pair (TP) interface (RJ45 socket) and an optical interface (SC). Through TP port, other TP components can be attached (Hub Ethernet 100 Mbps 4TX, Switches Ethernet 10/100 Mbps 5TX/2FX, 7TX…). The FL port offers connection to optical network (Ethernet Switch 10/100 Mbps 5TX/2FX,…).

Monitoring LEDs for:

- Power,

- RxData,

- Link status,

- Fault. Link status monitoring can be disabled. Operation in industrial area. Mounting on ISO/DIN rail. Low current consumption. Compact construction. You will find a detailed description for

construction of a local area network in network design and network installation in the “Ethernet Reference Manual” (Order no. 490USE13300).

Order No.

499NTR00100

FAULT

LA1 LA2

+24V*

+24V

FAULT

499NTR00100

ETHERNET CABLING SYSTEM Quick Reference Guide

ETHERNET TRANSCEIVER 100 Mbps TX/FX Fast ETHERNET Transceiver Media converter 100BASE-TX/100BASE-FX for ISO/DIN Rail

Warning

If warning notices are ignored, severe injury and/or material damage may occur.

Only appropriately qualified staff should work on or near this equipment. Such staff must be thoroughly acquainted with all the warnings and maintenance

We have checked that the contents of the technical publication agree with the hardware and software described. However, it is not possible to rule out deviations completely, so we are unable to guarantee complete agreement. However, the details in the technical publication are checked regularly. Any corrections which prove necessary are contained in subsequent editions.

We are grateful for suggestions for improvement.

We reserve the right to make technical modifications.

Permission is not given for the circulation or reproduction of this document, its use or the passing on of its contents unless granted

Note

We would point out that the content of these operating instructions is not part of, nor is it intended to amend an earlier or existing agreement, permit or legal relation-ship. All obligations on Schneider Automation arise from the respective purchasing agreement which also contains the full warranty conditions

which have sole applicability. These contractual warranty conditions are neither extended nor restricted by comments in these operating instructions.

We would furthermore point out that for reasons of simplicity, these operating instructions cannot

describe every conceivable problem associated with the use of this equipment. Should you require further information or should particular problems occur which are not treated in sufficient detail in the operating instructions, you can request the necessary information from your Schneider Electric regional sales office.

General

Electricity is used to operate this equipment. Comply in every detail with the safety requirements specified in the operating instructions regarding the voltages to apply!

measures contained in these operating instructions.

The proper and safe operation of this equipment assumes proper transport, appropriate storage and assembly and careful operation and maintenance.

Staff qualification requirements

Qualified staff within the meaning of these operating instructions or the warning notes are persons familiar with setting up, assembling, starting up and operating this product and who have appropriate qualifications to cover their

activities, such as:

- training or instruction/entitlement to switch circuits and equipment/systems on and off, ground them and identify them in accordance with current safety standards;

- training or instruction in accordance with current safety standards in looking after and using appropriate safety equipment;

- first aid training.

Warning

Ethernet Transceiver 100 Mbps TX/FX units are designed for operation with safe extra-low voltage. Accordingly, only safe extra-low voltages (SELV) conforming to IEC950/EN60950/VDE0805 may be connected to the supply voltage connections.

Safety guidelines

+ 4 hidden pages