INSTRUCTION
MANUAL
COMBINATION COOLER
SK150W SK150B SK100W SK1 00B
This manual contains important information including safety and installation instructions of the
appli
ances. Please read it carefully and keep handy for easy reference.
CONTENTS
IMPORTANT SAFETY
STRUCTURE AND INSTALLATION
ACCESSORY INSTALLATION BEFORE OPERA
OPERATING THE REFRIGERATOR
CARE AND
TROUBLESHOOTING..................................................................................................................P.10
REVERSE THE DOOR SWING..................................................................
MAINTENANCE........................................................................................................
INFORMATION
DRAWING..........................................................................
............................................................................................
........................................................................................
TING...............................................................
..............................P.12
P.1
.P.2
P.5
P.6
P.9
IMPORTANT SAFETY INFORMATION
To avoid the risk of fire, electrical shock, or injury when using the appliance, follow these basic
precautions:
● The appliance is intended to be used exclusively for the storage of beverages only.
● Plug into a grounded 3-pin outlet, do not remove grounding pin, do not use an adapter, and do not
use an extension cord.
● Never clean the appliance parts with flammable fluids which may create a fire hazard or explosion.
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of the appliance.
● Do not connect or disconnect the electric plug when your hands are wet.
● Unplug the appliance or disconnect power before cleaning, maintenance or servicing. Failure to do
so can result in electrical shock.
● Do not attem pt to repair or replace any part of the appliance unless it is specifically recommended in
this material or you are authorized to do so b y supplier. All other servicing should be referred to a
qualified technician, as assigned by supplier under your warranty period.
● Ensure when moving appliance to ta ke care and not dam age or drop.
● To ensure proper ventilation for the appliance, the front of the unit must be completely unobstructed.
Locate the unit away from direct sunlight and sources of heat (stove, heater, etc.).
● The fuse (or circuit breaker) size should be app. 10 amps.
● It is important for the appliance to be leveled in order to work properly. You may adjust the appliance’s
feet to level it, use spirit level if available.
● This appliance is not intended for use by young children.
● Do not use solvent-based cleaning agents of abrasives on the interior. These cleaners may damage
or discolor the interior, use hot water and lem on ju ic e or eu c al ypt us o il is bes t f or cle a nin g
● Do not use this appliance for other than its intended purpose.
● When you dispose the appliance, take off the door and leave the shelves in place so that children
may not easily climb inside. And make sure the coolant circuit, particularly the heat exchanger at the
back/bottom of the unit not be damaged. The symbol on the product or its packaging indicates
that this product is not to be handled as normal household waste and it is to be taken to a recycling
collection point for electrical and electronic goods.
2
3
SK100W or SK100B building into cabinetry under bench
SK150W or SK150B building into cabinetry under bench
4
SN
10 - 32 °C
N 16 - 32 °C
ST
18 - 38 °C
T 18 - 43 °C
G a s k e t
ACCESSORY INSTALLATION BEFORE OPERATING
UNPACKING AND CLEANING THE WINE COOLER
● Remove the exterior and interior packing materials.
● Let the appliance stand upright for approximately 2 hours before connecting it to the power
source, which helps to reduce the possibility of a cooling-system malfunction from handling
during transportation.
● Use a soft cloth to clean the interior surface with lukewarm water.
● Install the door handle provided with the appliance by following these steps:
1st step －Remove the gasket at the inner side of the door
to expose the two screw holes.
nd
2
step －Install the handle tightly with the screws
and washers provided.
3rd step －Tidy and restore the gasket.
F la t Washer
Locker Washer
S c r e w
H a n d le
Door F r a me
LOCK & UNLOCK THE DOOR (FOR OPTION)
● Lock is an optional function. If your Wine Cooler has such function, a key should be attached
inside the packing of this Manual.
● Insert the key into the lock and turn it counter-clockwise to unlock the door. To lock it, please
follow the reversed operation. Please save the key
OPERATION
WORKING CLIMATE
well.
● The appliance is designed for operating from SN to T climate (see below climate class chart). It
is recommended to maintain the ambient around 22-25°C which helps the appliance work with
low power consumption.
● If the ambient temperature is above or below the designed climate range, the performance of
the unit may be affected. For example, the appliance operating in extreme cold or hot conditions
may cause interior temperatures to fluctuate, and the temperature set 1-18°C may not be
reached
sometimes.
Climate Class Ambient Temp.
5
WINE STORAGE
Red Wines
15 - 18º C
Dry/White Wines
9 - 14º C
Rose Wines
10 - 11º C
● The standard wine shelves are designed perfectly for Bordeaux bottle storage (76mm >
80mm). The maximum loaded bottles may vary subject to the different size or dimension of the
wine bottles you store, as well as the shelves quantity pre-installed in the Wine Cooler.
● These are pull-out shelves:
The shelves are without telescopic rails, but
with a plastic stopper on each sides of the
shelf track to prevent bottles from falling.
See the right figure.
● To prevent damaging the door gasket, make sure to have the door opened fully all the way
before pulling the shelves out.
● Please store wine in sealed bottles.
● Should the wine cooler be left empty for long periods it is suggested that the appliance is
unplugged, and after careful cleaning, leave the door ajar to allow air to circulate inside the
cabinet in order to avoid possible condensation, mold or odours forming.
● Recommended Temperatures for chilling/storage your wines.
Sparkling Wines 5 - 8º C
Led Display Of Carel Controller
Interface
6
Explanation of the icons：
When controller is running
ON OFF
Flash
1
Compressor
ON
OFF
Request
2
Evaporator fan
ON OFF
Request
3
Defrost ON OFF
Request
4
Alarm
In alarm
No alarm
-
3 digits with decimal
, display range is -199…999.
Refer to parameters /4, /5, /6 about
Normal operation
Press for 1 second
Press for 3 second
Turn up the parameters list；
Mute the buzzer；
Turn on/off light；
Item
5
Function
Keypad introduction:
Digit
the type of probe displayed, values
, in °C/°F and decimal point.
Buttons
ON/OFF/UP
SET/MUTE
LIGHT/DOWN
Explanation of the buttons
Increase the value of parameter.
Select the parameter；
Save parameter value temporarily
Turn down the parameter list；
Decrease the value of parameter.
Switch on/off
Show “PS”，start setting parameters
Save parameter value permanently
/
How to set the temperature:
1) Press the “set” for three seconds
2) It will show the current ‘set’ temperature, you can then press” up” or “down” to
increase or decrease the temperature for 0.1 degree each time. Then hold ‘Set’ for 3
seconds until it returns to original display. The temp is now SET.
7
CARE AND MAINTENANCE
CLEANING THE WINE COOLER
● Turn off the power, unplug the appliance, and remove all items including shelves.
● Wipe the inside surfaces with a sponge and baking soda solution. The solution should be about
2 tablespoons of baking soda to 1 litre of warm water.
● Wash the shelves with a mild detergent solution. Allow wooden shelves to dry before placing
back into the wine cooler.
● Wring excess water out of the sponge or cloth when cleaning area of the controls, or any
electrical parts.
● Wipe the outside cabinet with warm water and mild liquid detergent. Dry with a clean soft cloth.
● Do not use steel wool or steel brush on the stainless steel. These will contaminate the stainless
steel with steel particles and rusting may occur.
POWER FAILURE
Most power failures are corrected within a few hours and should not affect the temperature of your
appliance if you minimize the number of times of door opening. If the power is going to be off for a
longer period of time, you need to take the proper steps to protect your contents.
MOVING THE WINE COOLER
● Remove all items.
● Securely tape down all loose items (shelves) inside your appliance.
● Turn the adjustable leg up to the base to avoid damage.
● Tape the door shut.
● Be sure the appliance stays secure in the upright position during transportation. Also protect
outside of appliance with a blanket, or similar item.
ENERGY SAVING TIPS
● The appliance should be located away from heat producing appliances, and away from direct
sunlight.
● Ensure that the unit is adequately ventilated. Never cover air vents
at front.
● Only open the door when necessary. Avoid leaving the door open for long periods or opening/
closing the door frequently.
● For beer units, when you are away, set at 8-10oC, this means much less energy consumption
and still will keep beverages from spoiling
● Keep unit at least ¾ full, this will ensure less run times, as less air to chill
● Every 12months or so check your rear wire condenser (behind panel) for dust and particle
build up, this can cause over running and overheating if blocked.
8
TROUBLESHOOTING
If you feel the appliance is out of order, follow these instructions to try to see if you can solve the
problem simply by yours elf be for e calli ng for s er v i c e.
PROBLEM
POSSIBLE C AUSE / MEASURE
The Wine Cooler does not operate Not plugged in.
The appliance is turned off.
The circuit breaker tripped or a blown fuse.
The Wine Cooler is not cold enough Check the temperature control setting.
External environment may require a higher setting.
The door is opened too frequently.
The door is not closed completely.
The door gasket does not seal properly.
Automatica lly tu rn-on and turn-off
frequently
The room temperature is hotter than normal.
A large amount of contents has been added to the
Wine Cooler.
The door is opened too frequently.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The lighting does not work
Not plugged in.
The circuit breaker tripped or a blown fuse.
The lighting is turned off.
Too much vibration Check to assure that the appliance is level.
Check to assure no parts inside the cabinet or in the
compressor chamber are loose.
The unit seems to make too much
noise
The rattling noise may come from the flow of the
refrigerant, which is normal, can sound like
water trickling.
As each cycle ends, you may hear ‘gurgling’
sounds caused by the flow of refrigerant.
The appliance is not level.
The door will not close properly. The unit is not level.
The door was reversed and not properly installed.
The gasket is dirty.
The shelves are out of position.
The display window is shown with “HH”
The temperature probe is out of order.
or “LL” instead of a digital figur e,
and/or with continuous buzz sound.
9
REVERSE THE DOOR SWING
FOR BUITL-UNDER SERIES
Remarks:
The instruction is based on a unit with right door hinge installed alre ady.
To reserve the door from right hinge to left hinge, you need to get ready 2 new spare parts: an
upper left hinge, and a bottom left hinge.
All removed parts must be saved to do the door reinstallation, except those remarked with
“Disused”.
1st step –Open the door, and loosen the 2 screws. See Figure 1.
2nd step – Carefully remove the door from the upper right hinge and prevent it from
scratching. Take out the support rod from the door hinge hole. See Figure 2.
3rd step – Pull out the 6 decorating plastic bolts covering the reserved hinge screw holes at the front
left corner of the cabinet.
4th step – Unscrew the upper rig ht hinge ○4 (Disused) and bottom left hing e ○6 (Disused) from
the cabinet. See Figure 3.
Install the upper left hinge ○7 and bott om left hinge○8 to the left side of the cabinet.
Make sure the screws are tightened. See Figure 4.
5th step – Put upside down the door and install it to the left hinges by following the opposite
steps of taking down of the door as described above.
6th step – Cover the hinge screw holes on the right side wi th the 6 decorating plastic bolts.
WARRANTY: Call Bar Fridges Australia on
1300 170640 8:30>7pm Mon-Fri, 9>12 Sat.
Or simply logon to the website, at warranty link on top
menu page.
You must have proof of purchase document.
www.bar-fridges-australia.com.au
Loading...