Schlage BE375 User Manual
*P516-865*
P516-865
Keyless Touchscreen Deadbolt
Model BE375
Alternate Faceplate
Prepare for Installation
Tools Needed
• Phillips screwdriver
• Tape Measure
• Pencil
Optional
• Flathead Screwdriver
• Wood Block
• Hammer
Installation Instructions
B Adjust bolt length, if necessary.
Measure the dimension shown. If the measurement is 2C\v” (70 mm),
extend the bolt.
2³⁄₈" (60 mm)
2³⁄₄" (70 mm)
IMPORTANT NOTES
DO NOT use a power drill for installation!
• Install and test lock with door open to avoid being locked out.
• If tailpiece is not installed,
insert into slot on the back of
the touchscreen and snap into
place.
A Check door dimensions.
See consumer.schlage.com/Service-Support for door preparation
instructions if dimensions are different.
2³⁄₄" (70 mm)
OR
³⁄₈" (60 mm)
1" (25 mm)
Door Edge
2¹⁄₈" (53 mm)
Hole
5¹⁄₂" (140 mm)
Minimum
OR
No adjustment needed. Rotate faceplate
180° to extend.
Extended
C Change faceplate, if necessary.
2 Install the touchscreen on the outside of the door.
Choose the drawing that matches your door edge.
Door Edge
No change necessary.
OR
Door Edge
Slide tailpiece through the slot in the bolt, and route wire over bolt.
3 Install the thumbturn assembly.
3a Rotate the thumbturn to a vertical position.
Install Lock
1 Install the bolt.
Actual Size
Bolt must remain retracted
OR
Wood Block
(Not Included)
CAUTION
throughout installation!
3b Remove the battery cover.
3c Route battery cable from the touchscreen through
the hole in the thumbturn assembly.
Retracted Extended
3d Place thumbturn assembly against the door and
secure with two (2) screws.
Actual Size
5 Install reinforcement plate and strike into door jamb.
Door Stop
For maximum
security, install
reinforcement
plate.
Actual Size
Actual Size
3e Connect the wires.
4 Install the included battery.
IMPORTANT
Route the battery wire so it won’t be pinched
by the cover!
Strike Cut-Out (not to scale)
1¹⁄₂" (38 mm)
1" (25 mm)
Deep
¹⁄₈" (3 mm)
Pilot Hole
1"
(25 mm)
Rotate 180˚
if door stop is
on le side.
2³⁄₄"
(70 mm)
¹⁄₈" (3 mm)
3" (76 mm) Deep
1¹⁄₈"
(29 mm)
4a Install the battery cover. Do not pinch the wires!
Loading...