Schlage B250PD Installation Instructions Manual

*P513-174*

B-Series Single Cylinder

P513-174

Lock

Parts Included

• (2) Keys

• (1) Cylinder

• (1) M\zn” (11 mm) ring &
hardened steel insert

• (1) Z\,” (3 mm) ring &
hardened steel insert

• (1) Driver bar

• (1) Latch

• (2) Mounting screws,
cylinders

Depending on size ordered, may include (2) Z\,” (3 mm) rings and
hardened steel inserts.

• (1) Strike

• (1) Strike dust box

• (1) Strike reinforcer

• (2) 3” (76 mm) mounting
screws, reinforcer

• (4) Mounting screws, latch
and strike

• (1) Thumbturn

NOTE:

Hollow metal doors must be properly reinforced for latch

support. If door reinforcement is not furnished, contact door

manufacturer, or use Schlage reinforcer #37-001 (specify door

thickness)

1 Select rings and inserts.

Installation InstructionsModel B250PD

2 Prepare the door.

2a Mark centerline on door face and edge.

2b Place template on door and drill a 1Z\x” (38 mm)

hole through the door face (from both sides to avoid
damaging wood).

Drill a 1” (25 mm) hole in door edge. Drill C\,” (10 mm) deeper
as illustrated.

C\,” (10 mm) deeper

1” (25 mm) Hole

1Z\x” (38 mm) Hole

Use chart to choose rings and inserts for door thickness
adjustment.

Door Thickness 5 Pin Cylinder 6 Pin Cylinder

1C\,” (35 mm)

1C\v” (44 mm)

A B 5 Pin 6 Pin

Ring Insert Ring Insert 1C\zn” (30 mm) 1B\zn” (33 mm)

5 Pin 6 Pin

B and A B and (2) A

B B and A

3 Install latch.

3a Rotate to adjust latch so that bolt faces door jamb.

3b Insert latch into hole. Line up and trace around

faceplate.

Use chisel to remove wood until the faceplate ts ush when latch

is fully inserted.

1C\,” (35 mm)

door

1C\v” (44 mm)

door

1C\,” (35 mm)

door

1C\v” (44 mm)

door

3c Install latch with provided screws.

5 Install cylinder.

5a Insert driver bar into cylinder.

4 Prepare door jamb.

4a Locate exact centerline of latch and mark centerline on

door jamb.

Mark drill points Z\v” (6 mm) above and below horizontal
centerline. Drill two (2) overlapping M\,” (22 mm) holes, ZZ\zn”
(17 mm) deep.

Clean out holes for strike box. Use strike as pattern for
cutout. Use chisel to remove wood Z\v” (6 mm) deep.

M\,” (22 mm) Hole

ZZ\zn” (17 mm) deep

Z\v” (6 mm)

Z\v” (6 mm) deep

5b With key removed, insert cylinder into rings (See Step

1) and guide driver bar into slot in latch.

Screw mounting screws from thumbturn through the inside
cylinder and tighten evenly.

4b Mark and drill C\zn” (4 mm) pilot holes for 3” wood

screws.

Install reinforcer, dust box, and strike with provided screws.

Customer Service

1-877-671-7011 www.allegion.com/us

P513-174 Rev. 01/14-e

© Allegion 2014

Printed in U.S.A.