SChERtLER TOM, TIM USER MANUAL
TIM & TOM
complete PA system 600W & 1000W
IMPORTANT SAFETY INSTRUCTIONS
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE PRESENCE OF
UNINSULATED “DANGEROUS VOLTAGE” WITHIN THE PRODUCT ENCLOSURE THAT MAY BE OF A SUFFICIENT MAGNITUDE TO CONSITUTE A RISK OF
ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE PRESENCE OF IMPORTANT OPERATING AND
MAINTENANCE INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE PRODUCT.
TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK
WARNING
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
DO NOT EXPOSE THE APPLIANCE TO RAIN OR HUMIDITY
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (inclu-
ding ampliers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The
wide blade or the third prong are provided for your safety. If the provided plug does not t into your outlet,
consult an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
11) Only use attachments/accessories specied by the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or table specied by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury
from tip-over.
13) Unplug this apparatus during lightning storms or when unused for long periods of time.
14) Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
WARNINGS
PRECAUTIONS
WARNINGS
Keep this manual for possible future needs
Pay attention not to pour liquids onto the device and do not operate in conditions of excessive humidity
Do not install the device close to sources of excessive heat, do not expose it to direct solar radiation and do not
position it without protection in a dusty environment
Be sure that the main voltage does not exceed the value indicated on the back panel
Do not use the device if the main cable or the plug aren’t in a perfect condition (if necessary, replace it)
If the main cable has to be replaced, the operation must be carried out by qualied personnel. Replace the cable
exclusively with one that is an exact substitute
In order to avoid interference, do not install the device close to power transformers, TV sets, RF transmitters, electric
motors or any source of electric energy
Do not point microphones against speakers: this could generate annoying whistles (Larsen effect) that cause damage
In order to avoid unpleasant and costly inconveniences, use only original connecting cables
Read carefully this manual and follow these
precautions before operating the device
To completely disconnect this apparatus from the AC mains, disconnect the power supply cord plug from the AC socket
When cleaning, do not use solvents (e.g. acetone or alcohol). These could damage the external nishing and the
serigraphy
Do not attempt to service this product. In case of malfunction of any part of the system call the nearest technical
assistance centre or a specialized technical centre
For good ventilation, the heat sink should never be covered or obstructed by blankets, sofas or similar furniture. Be
sure also to leave sufcient clearance between the heat sink and any other surface
No source of ames, e.g. candles, should be placed on or near the device
The device should not be exposed to water, even in small amounts. No object containing liquids should be placed on
or near the device
The device should only be connected to a mains socket outlet equipped with protection ground system
When the device is installed, be sure the mains socket and the plug of the mains cable are easily accessible
Loading...