Page 1
Scanstrut ROKK Wireless - Catch (SC-CW-08E)
24-06-2021 Issue 2
Installation Instructions
Technical Information
Scanstrut ROKK Wireless - Catch
Max phone size: 176mm (6.92”) x 94mm (3.70”)
(Including case)
Wireless charger (SC-CW-07E)
Input voltage range : 10-30V DC (12/24V system)
Input current max: 1.5A
Output power: 5W (5V, 1A)
Standby current draw: < 0.03W
Certications: Qi, CE, FCC, ROHS
Waterproof rating: IPX6 front and back
READ THE IMPORTANT SAFETY INFORMATION
LEAFLET BEFORE INSTALLING
1
Choose a at mounting location ensuring there is adequate
space around and behind the mounting surface. Use the
template provided to mark the corners and drill center for
hole saw.
Tools Required
Parts List
Hole Saw
ø
65mm (2.56”)
Powerdrill
2
Use ø65mm hole saw to cut the hole, deburr and
thoroughly clean surface with an alcohol wipe.
Phone Charging
Mat
x1
SC-CW-07E
Sub Wireless Charger
x1
Alcohol Wipe
x1
3
Peel o centre piece of self adhesive backing and remove
protective lm from the SC-CW-07E charger. Place the
SC-CW- 07E charger in recess.
5
Peel o the remaining self adhesive
backing from the charging mat, as
well as the self adhesive backing on
6
Guide the wire of SC-CW-07E through
hole and align charging mat. Once
aligned rmly press down into place.
the SC-CW-07E charger.
4
Ensure there is no air trapped between charger and self
adhesive tape.
7
Connect wires to 12/24V supply,
ensuring a waterproof connection.
Fuse according to input voltage
and current.
Loading...