Scanstrut SC24,SC27,SC28,SC25,SC26 Installation Instructions Manual

®

[phone] [e-mail] www.scanstrut.com

ACCESSORIES

INSTALLATION INSTRUCTIONS

Product Page no.

Radar Guards 3

Cable Conduit 4

Deck Flood Light 5

Nav Light, GPS & VHF Mount 6

Nav Light, GPS & VHF Extender Mounts 8

Lifting Crane 9

Mast Mount Adapter Kit 11

Adjustable Base Wedge 12

4° Base Wedge 14

Gantry Mount for Dual PowerTower® 15

Gantry Mount for PowerTower® 17

[phone] [e-mail] www.scanstrut.com

CONTENTS

®

Fitting Radar Guards

1. Once mast mount is fitted to the mast, install radar and radar guard.

2. Use the long fixing bolts supplied with the radar to attach the radar guard
and radar to the mast mount.

3. We advise the use of large washers under the bolt heads to spread the
load. We also advise the use of spring washers to prevent the fixing bolts
from loosening.

4. Fully tighten all fixings.

Radar Guard - SC24, SC25, SC26, SC27, SC28

Installation Instructions

SC24, SC25, SC26, SC27, SC28

Scanstrut Ltd. 1 Malt Mill, Totnes, Devon, UK TQ9 5NH Tel: [phone] Fax: [phone]

e-mail: [e-mail] website: www.scanstrut.com

Cable Conduit - SC33 / SC66

Installation Instructions

Kit Contents:

SC66 and SC33 supplied in lengths of 1.5m.
Each pack contains 10 lengths.

Also Required:

Rivets and Rivet Gun
OR
Self Tapping screws

Fitting SC66 and SC33 Cable Conduit

1. Plan cable route down the mast and cut conduit to appropriate lengths.

2. We recommend that the joints are staggered so that the joints are
covered.

3. This will help the installation to appear neat, with little bending.

4. Fixings can be either Rivets or Self Tapping Screws.

5. We recommend 4 fixings per length.

Scanstrut Ltd. 1 Malt Mill, Totnes, Devon, UK TQ9 5NH Tel: [phone] Fax: [phone]

e-mail: [e-mail] website: www.scanstrut.com

Deck Flood Light - SC117

Installation Instructions

Before starting this installation read the Hella Oval 100 mounting
instructions supplied. Consult a qualified marine electrician before starting
this installation.

SC117 Kit Contents:

- 1x Hella Deck Flood Light + nut/bolt

- 1x 3” Tube Clamp assembly

- 1x Stainless Steel bracket

- 1x M8x50 bolt

- 1x M8 washer

- 1x M8 Nyloc nut

- 2x M6x20 Hex Head Bolts

Fitting SC117 during SC100 pole installation (following point 7 on the SC100 pole
instruction sheet):

1. SC117 is designed to mount on the SC100 pole and is attached using the 3” clamps
provided. Assemble the 3” clamps and light mounting bracket around the pole at the
height at which you wish to mount the deck light (see Figure 1).

2. Drill a clearance hole in the UPVC cover strip for the light cable. Ø 6mm / ¼”.

3. Attach the light to the light mounting bracket using the fastenings provided.

* The deck light is factory fitted with 200mm of cable. This will need to be extended for
connection into the boat.

- 2x M6 Nyloc Nuts

- 4x M6 White nut/bolt covers

- 8x M6 Nylon Washers

Also Required:

- 2x 10mm Spanners

- 1x 13mm Spanner

- Ø6mm / 15/16” drill bit

3” Clamps

Figure 1

Please note the use of
spacer washers

Light Bracket

Hella Deck Flood Light

Figure 2

Scanstrut Ltd. 1 Malt Mill, Totnes, Devon, UK TQ9 5NH Tel: [phone] Fax: [phone]

e-mail: [e-mail] website: www.scanstrut.com

Nav Light Mount – SC110/SC113

GPS/VHF Antenna Mount – SC111/SC112

Installation Instructions

Please note that the SC113 comes with Hella NaviLED 360 all round white light pre-fitted and hard wired with

1.45m of cable.

Scanstrut Ltd. 1 Malt Mill, Totnes, Devon, UK TQ9 5NH Tel: [phone] Fax: [phone]

e-mail: [e-mail] website: www.scanstrut.com