Page 1
01-06-2022 (Issue 2)
SC120
Parts List Tools Required
Installation Instructions
Lifting Crane x1
10120
1
2
3" Clamp Pair x2
10452
60120
R-Clip
60665
4.8 x 16 Rivet
10407
Gasket x4
x1 x4
x8 x4
Apply 4x Gaskets onto
2x Clamp pairs.
Lifting Tackle x1
60621
M6 x 20mm Bolt
60060
M6 Nylock Nut
6005
Ferrule Plate x2
10121
60702
Nylon Washer x8
60068
Nut Covers x8
4
400 mm
(15.75")
2 x 10mm Spanners
ø 5mm (3/16")
Drill Bit
Mount Clamp Pairs 400mm (17.75")
apart. Check that clamps are aligned
correctly and tighten in place.
Rivet Gun
Measuring Tool
×
Assemble 2x Clamp pairs
onto Pole.
3
5
Rivet Clamps permanently
6
into position.
UK & International
+44 (0)1392531280
sales@scanstrut.com
Mark and Drill 8 x 5mm (3/16") holes
into Pole.
For further installation
and warranty information
please visit:
www.scanstrut.com
USA
+1 860 308 1416
usasales@scanstrut.com
Assemble Ferrule Plates onto
clamp pairs using xings.
Page 2
01-06-2022 (Issue 2)
SC120
7 8
Installation Instructions
Assemble Lifting Crane into the
Ferrule Plates. The crane should
swing freely.
Apply nut covers.
Insert the R-Clip to secure the Lifting
Crane. Release pin for Crane stowage.
Share your installation with us.
UK & International
+44 (0)1392531280
sales@scanstrut.com
@scanstrut
For further installation
and warranty information
please visit:
www.scanstrut.com
USA
+1 860 308 1416
usasales@scanstrut.com
Loading...