Scansonic M8 operation manual

H I F I L O U D S P E A K E R S
S8
02 06 08
OWNER’S MANUAL TROUBLESHOOTING LIMITED WARRANTY
H I F I L O U D S P E A K E R S
Ow ne r ’s m an ua l
S8
Introduction
Please read this manual fully before unpacking and installing the product.
Carton contents
During production and packing we have carefully checked and inspected this subwoofer.
After unpacking please check for any damage from transport. We recommend that you keep the original cartonbox and packing material for any future shipping.
In the cartonbox you will find:
1 Input cable, RCA phono type
Loudspeaker installation
The subwoofer requires connection to the mains power supply, so for your safety it is important that you read both this manual and the amplifier manual before connecting.
Subwoofer positioning
Variations in placement of your loudspeakers can produce dramatic differences in the way music sounds. No listening rooms are the same and therefore we encourage you to spend some time experimenting with which placements work best in your listening room. Position of subwoofers are however less critical compared with full-range loudspeakers because the low frequencies reproduced by a subwoofer are difficult to locate in the room. Trust your ears and be willing to experiment freely. You can start with our basic recommendations.
indicator lamp POWER LED (9) will now glow green and the subwoofer is active and ready to be used. Fig. 4.
The Scansonic S8 subwoofer has a built-in AUTO STANDBY function and after approximately 5 minuttes without any input signal the subwoofer will automatically switch off, and the indicator lamp POWER LED (9) will glow red. When an input signal is detected the subwoofer will become active and the indicator lamp POWER LED (9) will glow green.
Setting volume, frequency and phase
The volume, crossover and phase (controls 6, 7 and 8) can be adjusted on the rearpannel, and we recommend that you adjust the setting of these controls to your liking – try with different music and films. If you want more detailed informations on these control functions, we invite you to visit our homepage www.scansonic.dk.
Running-in period
We recommend a running-in time of your new Scansonic S8 subwoofer of approximately 15-20 hours at normal listening level before you decide on the final positioning and controls settings of the subwoofer . During the running-in time the drive units will settle in and perform as intended.
Care and cleaning
We don’t recommend use of any solvents or cleaners on Scansonic S8 lacquered cabinets, the cabinet surface usually only requires dusting or cleaning with a soft cloth (do not use water).
The grille fabric may be cleaned with a normal clothes brush or vacuumed carefully with the grille detached from the cabinet.
To begin with, the subwoofer should be positioned between the TV and one of your front loudspeakers. Fig. 1 - 3.
Connecting your subwoofer
We recommend that you read the manual of your amplifier or AV-receiver carefully before connecting your subwoofer.
First switch off amplifier and all equipment when connecting your subwoofer.
Connect the subwoofer input IN (4) and your amplifiers SUB out with the enclosed RCA phono cable.
Connect the subwoofer net cable (2) to the mains voltage , and push the POWER ON/OFF button (1) to ON position, the
Avoid touching the woofer drive unit, and do not use the subwoofer as a coffee or drinks table (risk of water being spilled into the subwoofer).
Disconnect the subwoofer from the mains supply if taken out of use for a longer period.
Environmental information
Scansonic S8 subwoofer comply with international directives on the Restriction of Hazardous Substances (RoHS) in electrical and electronic equipment and the disposal of Waste Electrical and Electronic Equipment (WEEE) - the crossed bin symbol indicates compliance and that the products must be appropriately recycled or processed in accordance with these directives.
H I F I L O U D S P E A K E R S
sub
sub
sub
S8
fig. 1 surround 5.1 fig. 2 surround 6.1 fig. 3 surround 7.1
Loading...
+ 5 hidden pages