ScanSense TC60M Data sheet

Range 50 to 600°C

•

Accurate to ± 1,5°C

•

Stabilie to ± 0,75°C

•

No liquids, safe dry

•

calibration

155 mm well depth

•

3 buttons - easy to use

•

APPROVAL

A-8737

TC60M Temperature Calibrator

Tek Know calibrators - have been designed to maintain high accuracy and stability under the most severe conditions. The portable calibrators are used on offshore rigs and by leading ship owners world-wide.

True calibration - no simulation. The calibrator generates true temperature reference.

Calibration standard - each calibrator supplied by Scan-Sense is calibrated against precision

equipment, which is traceable to national standards, and calibration certificates are supplied with each unit.

Tek Know calibrators - will fulfil requirements in connection with quality assurance programs as well as requirements from classification societies.

Portable - low weight and compact design make the calibrators ideal for “on site” calibration.

3 0 02

s a no

jsi V

e l

l u B .n

iseD

& e g

alloC .e

s neS-nacS ,htets

re j G ne

miS :otohP .

3 08

0 12 .M06C

w w w . s c a n s e n s e . n o

Scan-Sense AS is a Norwegian company specialising in design and manufacturing of high quality sensors/instrumentation and related soft

ware for measurement of temperature, pressure, load and force.

Scan-Sense

AS supplies portable temperature calibrators from -40°C to 1200°C and a range of EEx/IS approved portable pressure

calib

rators from vacuum to 1200 Bar.

Technical information

TC60M

Temperature range 50 to 600 °C

Resolution (displ

ay)

1 °C

Accuracy ± 1,5 °C

Stability ± 0,75 °C

Heating time 14 min.

Well depth 155 mm

Well dia. (3 holes) 4.5, 6.5 and 13.5 mm

Power supply 230 VAC, 50 Hz

110

VAC, 60 Hz

Power consumpsion 1600 Watt

Operating tem

p. 0 to 40°C

Dimension 117 x 300 x 245 mm

Weight

Approx. 5.5 kgs

Note

: Due to continuous product improvements, published specifications may change without notice.

Automatic Calibration

The dry block principle excludes the use of oil or other liquids

. A dry block with various diameters ensure

thermal contact to the sensor being tested.

Simp

ly place the sensor to be calibrated in the

calibrator. Set the temperatu

re. When stabilisation occurs

simp

ly read the true temperature from the calibrator and

recalibrate the sensor or system accordingly.