Scanreco G5CUR User Manual
Instruction Manual
G5 CU R
Document Revision Language
66063
A
English
Document type Document number PageRev
Instruction Manual 66063
Document information
Attribute Information
Document Type Instruction Manual
Title SCANRECO G5 CU R
Document No. 66063
Language English
Release date 2013-05-20
Original English
Release date (original) 2013-05-20
Author SCANRECO
Company SCANRECO AB, SWEDEN
All rights reserved
A
2 of 8
Design, equipment, technical data and specications are subject to change or improvement
without prior notice. The text in this instruction manual, or any part of it may not be reproduced
or transmitted in any form or by any means, including electronic, mechanical, photocopying,
recording, storage in an information retrieval system, or otherwise, without prior written permisÂsion of SCANRECO AB, SWEDEN.
Revision history
Revision Date Note
A 2013-05-20 First release
Document type Document number PageRev
Instruction Manual 66063
G5 receiver
Product description
The Central Unit (CU) is manufactured in robust plastic housing and provides contacts for
the connection of power supply and electro-hydraulic valves. Several of the outputs can
also be used as digital inputs. Depending on the version of the G5 Central unit, it can either
be equipped with MOSFET outputs and Deutsch connectors or can have relay outputs with
terminal block.
Since the central unit can be exposed to very tough environments, the box is encapsulated
to give protection from damp, heat, cold, dust, vibration and corrosive environments.
The Central unit has short circuit protected inputs and outputs and has protection against
reverse polarity, over-voltage, large incoming voltage transients and EMC/RF.
A
3 of 8
Relay output
The Relay output connectors are separated from the rest of the electronics in the
central unit to create an electrically isolated output. The maximum load for each
output is 10A. Through the terminal block, both the normally open and the normally
closed connection points are available.
Label
Loading...