Scanpak 25A1 Users Manual
Page 1 of 9
RFID TagAAA User Manual for Security & Tracking
Date: 01/Feb/2006
Prepared by:
Scanpak Inc.
2250 Place Transcanadienne
Dorval, Quebec
Canada H9P 2X5
Tel: 1-514-685-3505
Fax: 1-514-685-5484
www.scanpak.com
Page 2 of 9
TABLE OF CONTENTS
1. INTRODUCTION....................................................................................................... 3
2. DESCRIPTION.......................................................................................................... 4
3. PREPARING FOR INSTALLATION ..................................................................... 5
INSTALLATION CHECKLIST................................................................................................ 6
INSTALLATION GUIDELINES............................................................................................... 7
4. PREPARATION OF GALLEY EQUIPMENT.......................................................8
GALLEY EQUIPMENT CLEANING AND PREPARATION....................................................... 8
INSTALLATION OF THE TAG ...............................................................................................9
Page 3 of 9
1. Introduction
These installation procedures describe how to properly install an RFID Tag_AAA
in conformity with Scanpak’s standards.
First and foremost, this document presumes that you are familiar with Galley
Equipment or other metal bins equipments.
If you feel uncomfortable with any of the above tasks, immediately contact your
supervisor and discuss that matter with him or her.
This document will firstly present to you an installation checklist to make sure you
have all the equipments and tools required to a successful installation. Then, it
will guide you to make decisions regarding the positioning of the tag onto the
Galley Equipment.
"This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any itnerference received, including interference that
may caused undesired operation."
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR
TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO
THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
Loading...