BOLLA4
W
-DO NOT CRA
Cleaning and Car
Clean your BOLLAcor
soap and lukewarm water
emove any built-up
grime and soot. Then rinse of
but rather wipe it of
Dry BOLLA with a clean rag.
© 2009 Scale 1:1. All Rights Reserved.
www
36” height
.scale1to1.com
WL, STAND, OR SIT ON METAL SHELVING.
e Instructions:
e at least once every six months with a rag that has been dampened with
. Do not scrub, but use gentle, repetitive pressure to r
f with a rag dampened with clear, clean water. Do not spray it down,
f with the rag. You may need to do this several times to get all the soap off.
ARNING:
BOLLA
POP Shelving
ASSEMBLY INSTRUCTIONS:
Assemble the item on a soft, non-abrasive surface, such as carpet or cardboard to avoid
damaging the item. Seek assistance to assemble your Bolla Pop Shelf.
The assembly method of the Bolla shelving collection is the same for all models: Bolla 8, Bolla
6, Bolla 4 and Bolla 2. The model shown in the instruction booklet may vary from the unit
purchased.
About the glass:
The glass top suits all Bolla models as an additional top shelf. The glass top is available for
purchase as an accessory, sold separately. Please refer to your retailer for ordering. For
assembly instructions, please see the assembly instructions attached to the glass top.
NO TOOLS REQUIRED:
PARTS INCLUDED:
X2 FRAME
X4 STYRENE SHEETS
(COIL TO CREATE TUBE)
X4 METAL SHELF
X16 RIVETS
(4 PER TUBE)
X2 3/4” ASSEMBLY BRACE
Step 1.
Insert temporary wood bracing as shown. Location of each brace may very. Remove braces
after completing step 2.
BOLLA
POP Shelving
Step 3a.
Slots must be aligned with both frames, carefully allow the coiled tube to expand into the frame.
Assure that both frames are held by the slots of the plastic tube.
Step 3b.
Align the holes at both ends of the tube by expanding tube inside the frame. Insert the black
plastic ‘push-rivets’ through the holes to fasten both ends together.
Step 4.
Insert metal shelves
Insert rivet into hole.
Press in with thumb to
expand and lock rivet.
IMPORTANT:
Refer to your retailer for further details of your SCALE 1:1 product purchase policies.
Return policy is strictly under the retailer discretion. SCALE 1:1 is exempt of responsibility or
accepting product returns direct from a consumer when the product was not purchased direct
from SCALE 1:1’s inventory.
Loading...