Saxby Lighting 79196 Installation Instructions

Wiring
Having correctly identified the wiring from your existing light fitting, pull the wire through the hole and connect to the connection block inside the product in the following way:
Check that...
Instruction leaflet
Glover Wall lamp
79196
You have correctly identified the wires.
The connections are tight.
No loose strands have been left out of the
connection block.
When completed, ensure that there are no bare or
loose strands of wire exposed, and cover all exposed areas of the connection block with 2 layers of insulation tape.
Care and Safety
We recommend cleaning with a soft dry cloth. Do not use solvents or abrasive cleaners as these could
damage the finish.
For your safety, always switch off the supply before cleaning.
WWW.saxbylighting.com Saxby lighting. BH23 3PE
Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. Please retain these instructions for future reference.
Warning
Please read these instructions carefully before commencing any work.
This unit must be fitted by a competent and qualified electrician.
Install in accordance with IEE Wiring regulations and current Building Regulations.
Check the pack and make sure you have all of the parts listed.
To prevent electrocution switch off at mains supply before installing or maintaining this fitting. Ensure other persons cannot restore the electrical supply without your knowledge.
This light fitting should be connected to a fused circuit.
If replacing an existing fitting, make a careful note of the connections.
Cables must be protected using suitable conduit or plastic trunking.
The mains supply cable must have a minimum cross sectional area of 1.0mm².
This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should be scrapped.
Take care not to drill into any pipes or mains cables beneath the surface during mounting holes preparation.
This product is suitable for indoor use only and not for areas constantly subject to moisture such as bathrooms.
Technical data
Installation
Existing fittings must be completely removed before installation of a new product. Before removing the existing fitting, carefully note the position of each set of wires.
Note that the power needs to be isolated/switched off at the fuse board.
Remove 2 securing screws to separateterminal box from product.
Decide on the position of the luminaire. The product must be securely fixed to the mounting surface using the screws and wall plugs supplied. The screws and wall plugs supplied are suitable for "masonry " only.
Avoid locating any cables in positions that would cause a hazard. Position cables and connector block away from areas where they may be at risk from being cut, trapped or damaged.
Always refer to the installation drawing for the orientation of the product.
Power-on. Your light is now ready for use.
1 2 3 4 5 6
7
Supply
Voltage: 240V~, 50 Hz
Bulb Type:
IP44
2 x 5W LED SMD 4000K
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
Conformity with all relevant EC Directive requirements.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.Check with your Local Authority or local store for recycling advice.
Class I product, must be connected to earth.
This product is not suitable for dimming.
Splash-proof
See Wiring dragram
Loading...