Saxby Lighting 77895 Installation Instructions

Check that...
Commissioning
Fitting/replacing bulbs
Forca EM LED Bulkhead
77895
Recycling advice
Safety information
For your safety, always switch off the power supply before cleaning.
V2 14/02/2020
Installation
Warning
This product is Class 2 (Double insulated) and must not be earthed.
Please read these instructions carefully before commencing any work.
This unit must be fitted by a competent and qualified electrician.
Install in accordance with IEE Wiring regulations and current Building Regulations.
To prevent electrocution switch off at mains supply before installing or maintaining this fitting. Ensure other persons cannot restore the electrical supply without your knowledge. If you are in any doubt, please consult a qualified electrician.
Specification
Layout
This light fitting should be connected to a circuit with a 30mA RCD fitted.
If replacing an existing fitting, make a careful note of the connections.
This product contains non-replaceable parts and cannot be serviced. If damage occurs the part should be scrapped.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice.
This product is rated at IP65.
C
Battery warranty: 2 years
carefully note the position of each set of wires.
Wiring
PUSH DOWN
INSERT CABLE
Non-Maintained Wiring: The product is normally off and comes on during a power failure
PERMANENT
Individual casings
Maintained (Unswitched) Wiring: The product is on permanently and comes on during a power failure
LINK CABLE
PERMANENT
Maintained (Switched) Wiring: The product is used as a normal light - switch on/off, light turns on/off. Comes on during a power failure.
PERMANENT
SWITCHED LIVE
SWITCHED LIVE
Loading...