Savory SG, SG-18C Installation Manual
INSTALLATION & OPERATION MANUAL for SG Series
Hot Dog Grills
The SG Series hot dog grills have been designed to cook and hold a variety of products.
The dual 3-position cook and hold controls
allow for any volume demand from low to high.
The SG-18 grill has 10 rollers and 1 heating
zone. Both the SG-22 and SG-34 grills have 10
rollers and 2 independently controlled heating
zones for maximum flexibility,
Standard features include: exclusive grease
deflection rollers, total control push-button
operation, easily removable drip pan, and
rugged stainless steel construction. Models
with the suffix “C” have highly polished metal
rollers. Models with the suffix “S” have nonstick coated rollers.
BEFORE INSTALLATION
NOTE: Upon receipt of this unit, immediately unpack and inspect for possible concealed
shipping damage. If unit is found to be damaged, save all packing materials and contact your
delivery carrier within 5 days. Refer to “Shipping Damage Instructions” enclosed for detailed
instructions. Failure to follow these instructions will negate Merco/Savory’s or your ability to
file claims and receive compensation for shipping damage.
This manual contains important safety and installation-operation instructions. Require all operators to read this
manual before using the unit. Failure to follow the instructions contained in this manual may cause injury, damage to the unit, and will void the warranty.
THIS MANUAL SHOULD BE RETAINED FOR FUTURE USE
0201-JDM 07088
INSTALLATION INSTRUCTIONS
Place the SG Series Hot Dog Grill in the most convenient location for ease of cleaning, maintenance and general operation.
When installing this unit, avoid locations with drafts, close proximity to grease or vapor-producing appliances or other high
ambient heat equipment. Allow sufficient overhead clearance for heat dissipation. A minimum of 1” clearance is required
on all sides for proper air circulation.
WARNING
This unit must be used with voltage
As specified on the unit data plate located on
the rear panel. Use of any other voltage,
Or altering plug will damage unit, void
The warranty, and may cause injury.
ELECTRICAL SPECIFICATIONS
The circuit on which the receptacle is installed must be of adequate wiring size and sufficient capacity to meet the
requirements indicated on the unit data plate and in accordance with the National Electrical Code and local
electrical installation codes.
OPERATION INSTRUCTIONS
WARNING
HOT SURFACES ARE PRESENT
USE CAUTION WHILE OPERATING THIS UNIT
2
Loading...