Saunatec INFRARED WOODEN SAUNA ROOM, IG-520 BH User Manual

INFRARED WOODEN SAUNA ROOM INSTRUCTION MANUAL

Read all instructions carefully before using the wooden infrared sauna room

IG-520 BH

PRECAUTIONS FOR USE.......................................................1

PARTS NAMES...............................................................2

READ BEFORE INSTALLATION..................................................3

INSTALLATION OF SAUNA ROOM BODY ..............................................4-7

CONTROL PANEL INSTRUCTION ...............................................8

COLOR LIGHT THERAPY SYSTEM............................................9

WARNINGS AND SUGGESTIONS FOR USE..........................................10

CLEANING AND STORAGE......................................................10

SPECIFICATION.............................................................10

SAUNA CIRCUIT DIAGRAM.....................................................11

IG-520-BH-2 5/25/07

ATTENTION

※Read all instructions before using this appliance.
※Serious injury may result if warnings and instructions below are not observed.
※When using an electrical appliance, basic precautions should always be followed,

including the following:

DANGER
To reduce the risk of burns, fire, electric shock, or injury to persons.

※Connect the power cord to a properly grounded outlet only.
※Use this appliance only for its intended use as described in this manual. Do not use

attachments not recommended by the manufacturer.

※Always unplug this appliance from the electrical outlet immediately after using.
※Keep the electrical cord away from heated surfaces.
※Heaters shall not be subjected to water spray; shower heads shall not be installed

within the sauna room.
※If the temperature limiting control reset switch trips frequently, a qualified service
person should be contacted.
※Never operate this appliance if it has a damaged cord or plug, if it is not working
properly or if it has been dropped or damaged. For technical support or questions
on operating the sauna please call the Saunatec National Customer Service
Center toll-free at [phone]; or email the Service Center at
[e-mail].

WARNING
※If you have any health problem or condition, consult your physician for permission to
use the sauna room. (“health problem”includes but is not limited to: acute diseases,
malignant tumors, high blood pressure, heart disease, allergic dermatitis, pregnancy, etc.)

※The sauna room should not be used by children.
※Should you have any abnormal feeling with your body while using the sauna, immediately

exit the sauna.
※If you feel uncomfortable while using the sauna, stop immediately and consult with
your doctor.
※The use of alcohol, drugs, or medication is capable of greatly increasing the risk of fatal

hyperthermia.

※Discontinue use if nervousness, tremor, headache, feeling of sickness or nausea occurs.

HYPERTHERMIA

Prolonged exposure of the user in the sauna room is capable of inducing hyperthermia.
Hyperthermia occurs when the internal temperature of the body reaches a level several degrees
above the normal body temperature of 98.6°F. The symptoms of hyperthermia include an
increase in the internal temperature of the body, dizziness, lethargy, drowsiness, and fainting.
The effects of hyperthermia include:
a) Failure to perceive heat
b) Failure to recognize the need to exit the room
c) Unawareness of impending heat
d) Fetal damage in pregnant women
e) Physical inability to exit the room
f) Unconsciousness

IG-520-BH-2 5/25/07

PARTS N AMES

IG-520-BH-2 5/25/07

READ BEFORE INSTALLATION:

※ Each panel is heavy. Be careful to avoid injury when installing, especially the top panel.
※ Two adults are required for the installation of sauna room.
※ There is a “+” button or a “–” button at the sides of each panel, which will be

installed

correspondently with one “+” to one “–” in following way when installing: The panel with

“+”button should be lifted up about 4 inches (10cm) higher than the panel with the “-“ button
(Refer to Picture 1); place the “+” panel against the panel with “–”button (Refer to Picture

2),and then slide down the panel with “+”button until the two panels are equal in height
(Refer to Picture 3). If they are not equal in height or there is an obvious gap between the
two panels, that means they are not properly attached, and you should try again.

The panels should be installed in the following order:
※ Floor Panel→Back Panel→Left Side Panel→Right Side Panel→Bench Support Panel
→Bench Surface Panel→Front Panel→Top Panel

IG-520-BH-2 5/25/07