sasportonline.com
Sales & Service
SA Sport (Canada) SA Sport (U.S.A.)
135 Forestview Road 7879 Will Rogers Blvd.
P.O. Box 40 Fort Worth, Texas
Orillia, Ontario USA 76140
Canada L3V 6H9
Telephone: (705) 325-2274 Telephone: (817) 536-3366
Fax: (705) 325-1485 Fax: (817) 536-3006
Toll Free: (800) 563-6479 Toll Free: (800) 331-8068
108 - CEILING HUNG RINGS
Before You Begin Assembly
Please read the following Instructions carefully before attempting to assemble these Ceiling
Hung rings.
Please note that under no circumstances should children be permitted to undertake assembly of
Ceiling Hung Rings. Only adults, coaches or other qualified persons should undertake the assembly
operation.
You have received One (1) shipping Carton containing the following components:
2 - Swivels
2 - Cable Thimbles
6 - Wire Rope Clips (Cable Clamps)
2 - Rings with straps and quick link attached
2 - Cables with thimble in fixed loop on one end for attachment to Ring Strap's quick link
Tools Required:
1 - Pliers for cotter pin assembly
2 - ¾" Wrenches
2 - ½" Wrenches
1 - Carpenters level
1 - Knife to strip plastic off Cable
1 - Wire rope cutter to cut excess cable
If your S/A Sport Beam Clamps have already been installed you are ready to begin assembly. If not,
Refer to 110 Beam Clamp Assembly instructions.
108 - Ceiling Hung Rings Instructions Rev1 8920071
1/
5
Swivel Attachment to Beam Clamps
1. Remove the bolts, washer, Cotter pin & Castle Nut from the underside of the Beam Clamps
2. Insert the top rounded end of the swivel between the two hanger brackets on the underside of
the beam Clamp.
3. Replace the bolt, washers, and castle nut as per figure A. Tighten securely using ¾"
wrenches.
4. Insert the cotter pin thru the castle nut and spread the Cotter Pin open to prevent the castle nut
from coming undone.
5. Install one of the Thimbles on the end of the swivel (figure B).
6. Repeat steps 2 to 5 for the second swivel.
7. Proceed to ‘Cable Attachment to Swivel’.
Note: It is suggested to determine the required length of cable and strip the plastic off the
steel cable prior to installing the cable to the swivels. Don’t shorten the cables until you
finish the installation, at which time the excess can be cut off.
108 - Ceiling Hung Rings Instructions Rev1 8920071
2/
5
Loading...