Sartorius L2200S,L 610,L2200P Installation And Operating Instructions Manual

Sartorius Laboratory.
L 610, L2200S, L2200P

Electronic Precision Balances

Installation and Operating Instructions

Advanced Test Equipment Rentals

www.atecorp.com 800-404-ATEC (2832)

®

E

s

t

a

b

l

i

s

h

e

d

1

9

8

1

2

1

Weighing pan

2

Weight display

3

ON/OFF key

4

CAL key

5

Tare control

6

Menu access switch (for the balance operating program)

7

Leveling foot (L 2200 S only)

8

Power receptacle

9

level indicator (L 2200 only)

3

Sartorius Laboratory
L 610, L 2200 S, L 2200 P

With this Sartorius Balance, you have acquired a sophisticated,
high-quality electronic precision weighing Instrument that will
help ease your daily work load.

Please read these Installation and operating instructions care­fully before operating your new balance.

Pursuant to the German Directive for the Implementation
of Regulations for Prevention of Accidents "Elektrische
Anlagen und Betriebsmittel (VBG 4)" [Electrical Installa­tions and Equipment] of April, 1986, it is hereby certified
that the equipment delivered, "Electronic Precision Bal­ance, model L 610, L 2200 S or L 2200 P," is manufac­tured and tested in compliance with the following
DIN/VDE regulations

DIN IEC348/VDE0411:
Safety requirements for electronic measuring apparatus

DIN IEC 380/VDE 0806:
Safety of electrically energized Office machines

DIN IEC 601 A/DE 0750:
Safety of medical electrical equipment

and with Article 10 of the Low Voltage Directive
73/23/EEC issued on February 19, 1973, by the Euro­pean Community.

When you use electrical equipment in installations and
under ambient conditions requiring higher safety Stan­dards, you must comply with the provisions as specified
in the applicable regulations for installation in your coun­try.

4

Contents

Equipment Supplied

5

Installation Instructions

6

Startup

7

Operation

8

Calibration 10

Balance Operating Program 11

Troubleshooting Guide 14

Accessories 15

Specifications 17

5

Equipment Supplied

Do not miss out on the benefits of our warranty.
Please complete the warranty registration card, indicating the
date of installation, and return the card to your Sartorius dealer.

The equipment supplied includes the components shown on the
left and a dust cover.

Save all parts of the packaging and the box for shipping your
balance to prevent any damage during transportation.

Installation Instructions

Ambient Conditions

Please choose a suitable place to set up your balance. lt should
not be exposed to the following:

— heat radiation
— aggressive/corrosive substances

— vibrations

— draughts

Do not expose the balance to extreme moisture over long peri­ods. Moisture in the air can condense on the surfaces of a cold
balance whenever it is brought to a substantially warmer place.
lf you Transfer the balance to a warmer area, make sure to
condition it for about 2 hours at room temperature, leaving it
unplugged. Afterwards, if you leave the balance connected to
mains power supply, the continuous positive difference in tem­perature between the inside of the balance and the outside will
practically rule out the effects of moisture condensation. The
components used in the balance are rated to at least Class KSF
according to DIN 40040.