Saris The T-Rax Sport 2 bike, The T-Rax Sport 4 bike User Manual
THE T-RAX SPORT
INSTALLATION MANUAL
Please READ and FOLLOW all instructions carefully.
T-Rax Sport 2 bike (502)
T-Rax Sport 4 bike (504)
1. MOUNT CARRIER TO VEHICLE
Tongue Weight Limitations
Hitch Type Tongue Weight Maximum Load
1-1/4”
200 lbs.
200 lbs.
300 lbs.
2 bikes/70 lbs.
3 bikes/105 lbs.
4 bikes/140 lbs.
2”
300 lbs.
300 lbs.
300 lbs.
2 bikes/70 lbs.
3 bikes/105 lbs.
4 bikes/140 lbs.
Remove adaptor bolt with 4mm hex wrench
provided.
*35lbs. per bike maximum
1A. 1-1/4” Receiver
Slide 2” adaptor off receiver.
Slide receiver into 1-1/4” hitch as illustrated.
Install threaded hitch pin bolt and lock washer
and fully tighten using 3/4” (19mm) wrench.
For added security part #3022 sold separately.
Slide receiver into 2” hitch as illustrated.
Install threaded hitch pin bolt and lock
washer fully tighten using 3/4” (19mm)
wrench. Install cotter pin.
For added security part #3022 sold separately.
Chances are, your bikes are just
like ours - your most valued
possessions. And if it has the
Saris name on it, nothing we
build goes out the door unless
it’s worth putting those possessions on. Call it obsessive. Call it
eccentric. We just chalk it up to
caring a hell of a lot about creating the last rack you’ll ever need.
FINALLY – A
COMPANY THAT
LOVES BIKES AS
MUCH AS YOU DO.
1B. 2” Receiver
Parts List
Item Description QTY
1 T-RAX unit 1
2
Receiver Base w/2”
adaptor
1
3
Pin with lanyard 1
4
Lock washer 1
5
Hitch pin bolt 1
6
Cotter pin 1
7
Sleeve 1
8
1/2” bolt 1
9
1/2” washer 1
10
1/2” nut 1
11
3/8” bolt 1
12
3/8” washer 1
13
3/8” nut 1
Tools Included: 4mm hex wrench
Tools Required: 3/4” (19mm) wrench x 2
9/16” wrench
MOUNT CARRIER TO VEHICLE CONTINUED:
Place lanyard
ring around
sleeve. Insert
final bolt into
receiver base,
through sleeve
and out through
the other side
of the receiver
base.
Attach 3/8” washer and nut.
Tighten with a 9/16” wrench.
Attach bolt and securely tighten all
bolts with two 3/4” wrenches.
7
8
9
5
6
Attach nut loosely-do not
fully tighten until all nuts
and bolts are loosely
placed.
Attach 1/2”washer.
2
Insert rack into the receiver base
and insert long bolt into receiver
and rack as shown.
Insert pin into
bottom hole as
shown.
(Note: Pin can be removed when
rack is empty to fold rack down.
Do not drive with rack in down
position)
Secure with clip.
3 4
Loading...