Saramonic SR-TM1 User Manual

DIRECTIONAL
CONDENSER MICROPHONE

The Saramonic SR-TM1 is a directional shotgun microphone features
a cardioid polar pattern, built-in rechargeable battery, 150 Hz low cut
switch, +6 dB high frequency boost, -10 db PAD and power button.

1 Introduction

The Saramonic SR-TM1 is a directional shotgun microphone features a cardioid
polar pattern, built-in rechargeable battery, 150 Hz low cut switch, +6 dB high
frequency boost, -10 db PAD and power button.

The SR-TM1 is very fit in several environments for applications such as DSLR
video making, ENG, filmmaking, field recording, sound design, and broadcast
applications.

2 Product Structure

150 Hz high pass filter button
+6 dB high frequency boost

-10 db PAD
Power button
Built-in Li-ion battery

Micro USB input
XLR output
Foam windshield
Mic clip
MicroUSB cable

SR-TM1

3 Power Supply

The TM1 can be powered via

• The built-in Lithium Battery; OR

• 48V phantom power, which is supplied by your camera or recording
devices (such as Saramonic SR-PAX2, SR-AX104, SR-AX107.) When phantom
power is applied, the built-in battery will not be used, or charged.

Power by Built-In Battery by 48V Phantom Power Low Power

Power Indicator Blue Light Green Light Red Light

4 Charge

Connect the SR-TM1 with the provided USB cable to a travel adapter, a computer
(slower charging speed) or any other USB port which provides standard 5 volts. It
will automatically start charging and all the 5 buttons will flash blue in cycles.
When the SR-TM1 has been fully charged, the 5 buttons will stay blue.
Pull out the cable and long press the power button to restart , now the SR-TM1 is
ready to use.

5 Highlights

• -10 dB Pad

Attenuates the microphone input to allow for the recording of loud sounds
without clipping.

• 150 Hz High Pass Filter

Reduces low frequency and infrasonic rumble from HVAC systems indoors or
street traffic outdoors from over-powering the recording.

• High Frequency Boost

Restores some of the high frequency content that is often lost when a blimp or
furry windshield is placed over the microphone and improves the intelligibility of
recorded speech.

• Rechargeable built-in Li-ion battery

The built-in battery supports at least 150 hours operation.

6 Specification

Acoustic Principle Line gradient

Directional Pattern Cardioid

Frequency Range 40 to 20k Hz (selectable HPF 150 Hz)

Sensitivity -35±3dB(0dB=1V/Pa,at 1KHz) 1.5V 2.2k

Ω

Output Impedance 200 ohm

Maximum Output 10 dBu (at 1 kHz, 1% THD into 1 kOhm)

Dynamic Range 119 dB (per IEC651)

Maximum SPL 135 dB

Signal to Noise Ratio 75 dB SPL (per IEC651)

Power

48V phantom power; built-in lithium battery (battery
life:150 hours)

Output Connection

3-pin XLR, balanced output between Pin 2 (+), Pin 3 (-) and
Pin 1 (ground)

Dimensions 2.3 x 2.3 x 28.2 cm

Weight 171g (About 6 oz.)

7 Packing List

• Micro USB cable

• Mic Clip

• Foam windshield

• SR-TM1 microphone

• XLR Cable

POLAR PATTERN

FLAT

HIGH BOOST

LOW CUT 150HZ