Sapido GS810w User Manual

Gigabit
Switch

8-Port Gigabit Ethernet
Switch

GS810w

Networking

User Manual

v1.0.0

TABLE OF CONTENTS

1 GETTING TO KNOW THE SWITCH 3

1.1 Introduction 3

1.2 Key Features 3

1.3 The Front Panel 3

1.3.1 LEDs status 4

1.4 The Rear Panel 4

1.4.1 Power Connector 5

1.4.2 Network Ports 5

1.4.3 Cabling 5

1.4.4 QoS/VLAN mode switch 5

1.4.4.1 QoS 5

1.4.4.2 VLAN 6

2 USEFUL TIPS 7

2.1 Prior to Installation 7

2.2 Half- and Full-Duplex 7

2.3 Auto-Negotiation 7

3 PRODUCT SPECIFICATIONS 9

2

1 Getting to know the Switch

1.1 Introduction

The Gigabit Ethernet Switch is equipped with 8 Gigabit copper ports and each port

provides a max speed of 2000Mbps and a Full-Duplex, Collision Free Bandwidth. It’s

a multi-speed, versatile network device that combines Gigabit, Fast Ethernet, and

Ethernet ports in a single device. This device meets RoHS compliance. It saves power

with Green Ethernet technology.

1.2 Key Features

 Supports Auto-Negotiation on each TP port



Supports 2047byte maximum packet length

 Supports Green Ethernet



Link-On and Cable Length Power Saving： The switch provides detection of

cable length and adjustment of power required for the detected cable length. This

feature provides high performance with minimum power consumption



Link-Down Power Saving：The switch implements link-down power saving on a

per-port basis, greatly cutting power consumption when the network cable is

disconnected greatly cutting power consumption when the network cable is

disconnected



IEEE 802.3az Energy Efficient Ethernet (EEE) supported： Energy Efficient

Ethernet (EEE) ability for 100Base-TX in full duplex operation, and supports

10Base-Te for 10Base-T in full/half duplex, which can reduce power consumption

during periods of low link utilization

 Provides Store-and-Forward switching scheme
 Supports Auto-MDI/MDI-X function
 Supports IEEE 802.3x Flow-Control for Full-Duplex operation
 Back-Pressure function supports for Half-Duplex operation
 2K-entry lookup MAC address table



Loop detection：If a loop is detected, the switch will drive the external LEDs and

buzzer alarm

 Supports QoS（Quality of Service）function
 Supports VLAN function

1.3 The Front Panel

3