Sanyo SF-P101N User Manual

SF-P101N

This document shows the differences in the 2 versions of the SF-P101N laser
assembly used in the following units:

VSCTV-3513 15pin
ENTERTAINER 15pin
DUET-I/DUET-II 15pin/16pin
RAVE 15pin/16pin
CDG-500/CDG-600 15pin/16pin
BRAVO (9-button) 15pin/16pin
TRIO 15pin
WANDERER-II 15pin

Laser Assemblies
When somebody wants to order a laser assembly for one of the above units,
you must first find out which version they need. THEY ARE BASICALLY
REFERRED TO AS THE 15pin and 16pin VERSIONS.

Desolder Points
When these laser assemblies are shipped to us, they are shipped with some
protective soldering that needs to be desoldered before installing. It is important
to let those who are ordering a laser assembly this prior to shipping them out.
The desolder points are illustrated below.

To take an order for a laser assembly for the above:

1) Check the above list, if the unit takes only the 15pin version, then that is
what is be ordered and you stop here. But if the unit can have both
versions installed, then you must ensure which version is correct for that
unit and move on to step two.

2) Have the technician pull out the assembly and count the pins on the main
ribbon terminal to decipher if it needs the 15pin or 16pin version.

3) Lastly make sure that the technician knows about the desolder point. If he
does not, tell him to save the old laser assembly to compare it with the
new one to see what is should look like after being desoldered.

15pin/16pin TOP VIEW