Sanyo SC-X2015N User Manual
Trouble shooting
If you have a problem with your cleaner, consult the handy guide below. If the cleaner
is malfunctioning, do not operate it and please ask for service.
Problem
Cleaner won’t run
Low suction
Cord doesn’t fully rewind
Possible cause Possible solution
1.Not firmly plugged in
1.Clogged floor brush,
hose or tube
2.Full of dust in the dust cup
3.Dust cup not in place
4.Clogged the filter
1.Cord twisted or uneven
Technical specification
Rating Voltage 230 240V-
Rating Frequency
Power Cord Length
50Hz
4.5m
Power
Dust Capacity
1.Plug unit in firmly
1.Remove the blockage
2.Empty the dust cup
3.Put the dust cap in place
4.Clean or replace the filter
1.Pull out the cord and rewind
1800-2000W
1.5L
Instrcution Manual
Vacuum Cleaner
SC-X2015N
7
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed
including the following
PLEASE READ ALL INSTRUCTIONS
CAREFULLY BEFORE USING THIS APPLIANCE
WARNING
To reduce the risk of fire electric shock or injury
Do not leave appliance when plugged in. Unplug from outlet when not in use.
Do not use outdoors or on wet surfaces.
Children should be supervised to ensure that they do not play with the
appliance.
The appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Use only as described in this manual. Use only supplied attachments.
Do not use with damaged cord or plug. If appliance is not working as it should,
has been dropped, damaged, left outdoors or dropped into water, it must be
repaired by qualified service agent.
Do not pull or carry by cord, pedal cord, use cord as a handle, close a door on
cord or pull cord around sharp edges or corners. Do not run appliance over
cord. Keep cord away from heated surfaces. (Figure 1 & 2)
Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
(Figure 3)
Do not handle plug or appliance with wet hands.
Do not put any object into openings. Do not use with any opening blocked;
keep free of dust, lint, hair, and anything that may reduce air flow.
Keep hair, loose clothing, fingers and all parts of body away from openings
and moving parts.
,:
3. Take the HEPA filter( ) out in the direction shown to clean. To clean it
22
completely, wash the filter in water and dry completely before put it back
into the cleaner. Be sure to dry naturally to prevent deformation. (Figure
16 & 17)
4. Clean the dust cup with water if necessary.
(Figure 18)
Clean outlet filter
1. Press the button on the outlet filter cover ( ) to take out the outlet filters
10
(Figure 19)
().
9
2. Wash the filters in water and dry completely before put them back into the
cleaner. Be sure to dry naturally to prevent deformation.
5
23
10
9
22
(Figure 20)
Storage
When not in use, hook the tube holder on the telescopic tube onto the tube holder
hole ( )on the dust cup handle. (Figure 21)
14
14
21
1
6
Loading...