Sanyo POA-RCKIT02 User Manual

PRESENTATION REMOTE CONTROL

MODEL POA-RCKIT02

Operating Instruction

Voor de klanten in Nederland

Bij dit product zijn batterijen geleverd.
Wanneer deze leeg zijn, moet u ze niet
weggooien maar inleveren als KCA.

The CE Mark is a Directive conformity
mark of the European Community (EC).

English

Français

Español

Deutsch

Italiano

日本語

Federal Communication Commission Notice

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures :

– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.

Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of FCC Rules.

Do not make any changes or modifications to the equipment unless otherwise specified in the instructions.
If such changes or modifications should be made, you could be required to stop operation of the equipment.

Model Number : POA-RCKIT02
Trade Name : Sanyo
Responsible party : SANYO FISHER COMPANY

Address : 21605 Plummer Street, Chatsworth, California 91311

Telephone No. : [phone]

FOR HOME OR OFFICE USE

Tested To Comply
With FCC Standards

2

Installation

Connect the computer's monitor output
terminal to the projector's input terminal with
the VGA cable.

30°

30°

Connect the Presentation Remote Receiver to
the USB port of your computer.

1

2

VGA cable

Presentation
Remote Receiver

Presentation
Remote Control

16.4’(5 m)

Note :

– The Presentation Remote Receiver can only be connected

with a standard USB port.

– Some computer settings may have to be changed in order

for the mouse function to be used. Refer to your
computer's owner's manual for details.

– When switching the remote control code of the projector

and the remote control, that of the presentation remote
control also needs to be switched. Press and hold both
the FREEZE and P-TIMER buttons together for 10 seconds
or more to switch the code. (For detail, refer to the
projector owner's manual.)

Presentation Remote
Receiver and Projector
Remote Receiver.

To insure safe operation, please observe the following precautions :

● Use (2) AAA, SUM-4 or LR03 type alkaline batteries.

● Replace two batteries at the same time.

● Do not use a new battery with a used battery.

● Avoid contact with water or liquid.

● Do not expose the remote control to moisture, or heat.

● Do not drop the remote control.

● If a battery has leaked on remote control, carefully wipe case clean and install new batteries.

● Risk of explosion if battery is replaced by an incorrect type.

● Dispose of used batteries according to the instructions.

Remove the battery
compartment lid.

Slide the batteries into
the compartment.

Replace the compartment
lid.

Two AAA size batteries

For correct polarity (+ and
–), be sure battery terminals
are in contact with pins in
compartment.

12 3

Remote Control Battery Installation

Install the batteries into the Remote Control
with following the instruction below.

3

Note : Read carefully the battery precautions in the projector owner's manual.

English