Sanyo POA-MD26HDWL User Manual

Owner’s Manual

HD DATA WIRELESS Receiver Board
Model POA-MD26HDWL

This interface board can be used to receive
the high definition digital image data
which is transmitted from the HD DATA
WIRELESS Transmitter Box (POA-HDTM01).

This interface board is only used for our
LCD projector that has a slot for a digital
signal input board.
Contact a sales dealer for suitable projec­tors.

A copy of Declaration of Conformity (DoC) is printed in
the owner's manual for HD DATA WIRELESS Transmitter
Box POA-HDTM01.

This is the manual for the method of installing this board.
Read the owner's manual of the HD DATA WIRELESS Transmitter Box (POA-HDTM01) and
the projector to understand the operations and the safety instructions.
The safety instructions in the owner's manuals should be followed strictly.

Important Notice

There are restrictions on the channels and frequencies in the countries and regions at which
you can use the wireless communication. So it is forbidden to take the transmitter and the
receiver outside the country or region where you purchased them.

Installation

Part Names and Functions

q w

LINK INDICATOR

q

When the wireless conguration is set
up correctly and the wireless communi­cation is established with the transmit­ter, this indicator lights orange.

POWER INDICATOR

w

When this receiver is selected in the
projector, this indicator lights green
during operation.

Installing the Receiver Board into the Projector

Insert the HD DATA WIRELESS Receiver
board. The cover of the board protrudes
from the cabinet of the projector.
We recommend that the HD DATA WIRE­LESS Receiver board is inserted into the
top slot for preventing influence from
the cables of other slots.

✔Note:

- In the event of replacement of interface
board, turn off the projector, press the
Main On/Off Switch to Off and unplug
the AC power cord from the AC outlet.

1 Remove 2 Screws from an interface

board or a slot cover.

2 Pull out the interface board or a slot

cover.

3 Insert the HD DATA WIRELESS Receiver

board along Guide to fit Plug into
Socket.

4 Tighten 2 screws to secure the HD

DATA WIRELESS Receiver board.

Plug

Slot Cover or
Interface Board

Screws

Guide

Socket

Screws

✐ 1 (one) HD DATA WIRELESS Receiver Board is available in 1 (one) projector.

2