LCD PROJECTOR LENS
MODEL NO. PLC-LNS07
PLC-LNS08
LENS REPLACEMENT PROCEDURE
● The focus and zoom of this lens can’t be adjusted by controls on main cabinet or the remote control unit.
NOTES ON LENS REPLACEMENT
Lens replacement should be performed by the qualified service personnel. It should be followed by this procedure precisely.
Before attempt to replace the lens, confirm the model number (both the LCD projector and the lens) and use the proper lens.
If you have any questions, contact to the dealers.
PARTS LIST
Following parts are contained in the packing.
· LENS |
1 piece |
· LENS MOUNTING SCREWS |
6 screws (2 for spare) |
· DRIVER |
1 piece |
· LIGHT-BLOCK SHEET |
1 sheet |
· LENS COVER |
1 set |
Following checks and confirmations should be taken for safety.
Check the following things by the time of the cabinet cover installation after the lens replacement.
1.Confirm the proper wiring and the wires are fixed properly.
2.Confirm the each connector is connected properly.
3.Wiring must not be tangled in the gear of the lens motor or the other mechanical part.
4.There is no missing part, or no loosing mounting part.
1AA6P1P1732-- (ICKV)
LENS REPLACEMENT PROCEDURE
Perform the steps 1 to 5 for lens replacement.
1 REMOVE THE LENS COVER. (See figure-1.)
1. Turn on the LCD projector.
2. Adjust the lens shift, so that lens is set in the center.
3. Turn off the LCD projector and disconnect the power cord from the AC outlet.
4. Remove 4 screws of the lens cover and remove the lens cover.
LENS COVER
Fig-1
2 REMOVE THE LENS. (See figure-2.)
1.Remove the connector “K16B” of the circuit board.
2.Loosen the A, B wire bands, wire holder and remove the lens motor lead.
After removal of the lens motor lead, fasten it by placing it back into position.
3.Remove screws D(4 screws) which fastens the lens and remove the lens.
Figure shown inside of the cabinet. |
LENS MOTOR |
C |
|
|
|
(D) |
(D) |
|
A
(D) (D)
B |
|
|
WIRE HOLDER |
This part wiring should |
|
not be tightened. |
||
|
||
LENS |
Fig-2 |
|
MOTOR LEAD |
||
|
CONNECTOR “ K16B “