Sanyo LNS-W01Z, LNS-T01Z User Manual

LCD PROJECTOR LENS
MODEL NO. LNS-W01Z / LNS-T01Z
LENS REPLACEMENT AND INSTALLATION PROCEDURES
NOTES ON REPLACEMENT AND INSTALLATION
The procedures and the needed pars for lens installation depend on the type of cabinet. Before installing or replacing the lens, make sure the type of cabinet and be sure to refer to the Installation Manual corresponding with your projector. When installing or replacing the lens, make sure the Lens Model No. matches with your projector. Refer to the catalog, or contact your sales dealer for the proper Lens Model No.
TYPE OF THE CABINET AND REFERENCE INSTALLATION MANUAL
Refer to the Installation Manual corresponding to your projector. (See the chart below.)
Type of the Cabinet Reference Installation Manual
Refer to this manual.
Refer to the Installation Manual supplied with the Projector.
Other than the above cabinet design.
Some parts are not used for installation or replacement. Keep these parts for later use.
Note : Figures in this manual may be differ from the actual product.
NOTES ON LENS INSTALLATION
The ZOOM and FOCUS adjustment on the Top Control or the Remote Control can­not be operated with this Lens.
• Lens installation and replacement should be made by the qualified service per­sonnel.
• Be sure to install the lens following this procedure precisely.
• The lens cover is on the lens for protection. Be sure to replace the lens cover before installation.
• When installing or replacing the lens, be careful not to stain, scratch or damage the lens.
After installing or replacing the lens, be sure to check the following for safety.
1. Check the lens is securely fixed by 4 screws.
2. Check no wiring is tangled on the gear of lens motor or the other mechanical
parts.
3. Check no part is missing, or no mounting part is loose.
BE SURE TO CHECK FOR SAFETY
LIST OF CONTENTS
Following parts are included in the packing.
• LENS 1 pc.
• LENS MOUNTING SCREWS 2 pcs. (for spare)
• DRIVER 1 pc.
• LIGHT-BLOCK SHEET 1 pc.
+ 2 hidden pages