CLT9930 (SANYO) A5 2nd 6/27/00 6:42 PM Page 1
INSTRUCTION MANUAL
900-MHz
Digital Spread Spectrum Cordless Telephone
CLT-9930
IMPORTANT
Charge the handset battery pack for 15 hours before using your cordless handset for the first time.
www.sanyocanada.com
Français au verso
CLT9930 (SANYO) A5 2nd 6/27/00 6:42 PM Page 2
Introduction
Congratulations on your purchase of the CLT-9930 cordless telephone.
This phone is designed for reliability, long life, and outstanding performance utilizing the latest in 900 MHz Digital Spread Spectrum technology.
Note: Some illustrations in this manual may differ from the actual unit for explanation purposes.
Features
●900 MHz Digital Spread Spectrum
●Lighted Handset Keypad
●10-Number Memory Dialing
●Last Number Redial
●7-Day Standby Battery Life/6-Hour Talk
●20-Channel Auto/Manual Scan
●Pulse/Tone Dialing
●Page/Handset Locator
●Handset Earpiece and Ringer Volume
●Belt Clip and Headset Jack
●Wall-Mountable
●Hearing Aid Compatible
●HandsFree Speakerphone in the handset
Digital Spread Spectrum Technology utifrequency band” vs. a “single narrow
in standard digital transmissions. The clarity of digital sound, extended range conversation with virtually no interferother 900 MHz cordless phones or radio
devices.
channel is automatically selected for
. The phone selects one of over security codes for the handset and
enhance your phone’s security and unauthorized calls as a result of your activated by other equipment.
Included with Your Phone
Base
AC adaptor (AD-210)
Also included:
•This Owner’s Manual
•Index Card
Belt clip
(SANYO 3KR-600AAL)
Telephone line cord (1), long |
Bottom bracket |
|
for desktop use and |
• Battery order sheet |
wall-mounting |
|
CLT9930 (SANYO) A5 2nd 6/27/00 6:42 PM Page 3
Controls and Functions
1
2
3 |
|
|
4 |
9 |
|
5 |
10 |
|
11 |
||
|
||
|
12 |
indicates when phone is in
places calls or hangs up a
dialing in pulse dialing
number
in a memory dialing
when the HandsFree
(if available) numbers in memory
channel for clear reception microphone while you
conversation using
piece and ringer volume handset in base for wall
the phone is in use or the
handset
13
14
15
E2
CLT9930 (SANYO) A5 2nd 6/27/00 6:42 PM Page 4
Installation
Charging the Battery Pack
The rechargeable Nickel-Cadmium must be fully charged before using your the first time. Before plugging the your new phone, you must charge
for at least 15 hours without interruption
1Remove the handset battery cover
2Plug the battery’s
cable into the handset and place the battery pack inside the battery compartment.
The connectors will fit together way. Make sure the battery’s is properly aligned. Use only battery pack (model 3KRPCF01).
3Replace the battery cover.
▼ Charging the Handset
Place the handset on the base to charge. (The handset can charge in either the face-up or facedown position.)
▼ Low Battery Indicator
When the battery pack in the handset is low and needs to be charged, the TALK/BATT LOW
LED flashes every 4 seconds.
If this occurs while you are on
the phone, you will hear an alert tone. Complete your call as
quickly as possible, and return
the handset to the base for charging.
Rechargeable batteries have effect that reduces standby time. To avoid this memory monthly basis use the phone low battery indicator appears charge the battery for 15
Repeated short chargings memory effect in the handset is recommended not to handset to the base after
the Battery Contacts
good
portant to contacts and base month.
or other
.
liquids or solvents.
a Location
a location for your new phone, important guidelines you should
should be close to both a phone jack power outlet.
A continuous power outlet is an AC outlet which does not have a switch to interrupt its power.
Unit and
from sources of such as: motors lighting.
is sufficient space Base Unit antenna
vertical position.
Important: Do not place the power cord in an area where it may create a trip hazard or become chafed and create a fire or electrical hazard.
Dialing Mode Switch
in the |
PULSE TONE |
for tone |
|
PULSE |
|
pulse dialing. |
|
RECYCLING NICKEL-CADMIUM BATTERIES
NICKEL-CADMIUM
BATTERIES MUST BE
DISPOSED OF Ni-Cd PROPERLY.
Nickel-cadmium cells are used in the battery pack. Please take your used nickel-cadmium battery packs to a store that recycles nickel-cadmium batteries.
E3