Sanyo CE28WN4J-B, CE32WN4J-B Instruction Manual
CE28WN4J-B
CE32WN4J-B
Please read this Instruction book before using your television.
We wish you many hours of pleasure from your new television.
Colour Television
INSTRUCTION MANUAL
Common specification
Power source AC 220~240V 50Hz
Television system System I
Colour system PAL/NTSC4.43
(PAL/NTSC4.43/NTSC3.58 in AV mode)
Channel coverage UHF: 21-69,
Aerial input impedance 75 ohm
AV terminal
AV1: CENELEC Standard
Input: Composite video, RGB and audio-L/R
Output: TV-output with composite video and
audio-L/R
AV2: CENELECStandard
Input: Composite video, RGB, S-VHS and
audio-L/R
Output: Monitor-output with composite video and
audio-L/R
Front AV terminal
AV3: RCAjacks
Input: Composite video and audio-L/R
Heaphone socket Mini Jack
CE28WN4J-B CE32WN4J-B
Sound output
(Continuous) 2 x 5W 2 x 5W
Picture tubes
(inches) 28 32
Dimensions
(WxHxD mm)
779 x 524 x 511.5 880 x 577.5 x 567
Weight (kg) 32.5 46.3
TV Specifications
2
SAFETY
SAFETY
PRECAUTIONS
PRECAUTIONS
Do not allow anything to rest on the power cord. Do not locate
this television receiver where the cord will be damaged by
people walking on it.
Do not overload wall outlets and extension cords as this can
result in fire or electric shock.
Slots and openings in the cabinet and in the back or bottom are
provided for ventilation to ensure reliable operation and to protect it from overheating. These openings
must not be blocked or
covered. The opening
should never be covered with a cloth or
other material, and the bottom openings
should not be blocked
by placing the television receiver on a bed, sofa, rug, or other
similar surface. This television receiver
should never be placed
near or over a radiator or heater.
Do not place your television receiver on an unstable stand, shelf
or table. Serious injury to an individual, and damage to the
television may result if it should fall. Your sales person can
recommend approved stands or shelf and wall mounting
instructions.
This television receiver
should not be placed in a built-in
installation such as a bookcase unless proper ventilation is
provided.
If the television is built into a unit, or enclosed, the minimum
distances for ventilation must be maintained. Heat build up can
reduce the life of your television, and can be dangerous.
This television receiver should be operated only from the type of
power source indicated on the television or as indicated in the
Operating Instructions. If you are not sure of the type of power
supply in your home, consult your sales person or your local
power company.
Never add accessories that have not been specifically designed
for this television.
Do not drop or push objects into the
television cabinet slots or openings. Some
internal parts carry hazardous voltages and
contact may result in an electric shock
hazard.
Never spill liquids of any kind on
the television receiver.
Do not place items
such as vases containing liquid on top of
the TV set.
Do not expose the television receiver to rain or use near water.
For example, near a bathtub, kitchen sink, in a wet basement,
etc. Before cleaning, unplug the television receiver from the wall
socket.
Never stand on, lean on or push the
television or its stand.
Never allow children
to play with the television or its stand.
Serious injury may result if it should fall.
Do not apply liquid cleaners or aerosol
cleaners directly onto the television receiver. Use a damp cloth for cleaning.
Do not place candles or hot objects upon
the TV, next to it or behind it. Open flames
must never be used near the TV set.
MINIMUM DISTANCES
Installation
Use
CAUTION: Please read and retain for your safety. This unit has been engineered and manufactured to assure your personal safety.
But improper use can result in potential electric shock or fire hazards. In order not to defeat the safeguards incorporated in this receiver
observe the following basic rules for its installation, use and servicing.
Your television is fully transistorised and does not contain any
user serviceable components.
You must not remove the rear cover of the TV by yourself. The
apparatus is working with high voltages and could damage
objects or even endanger people. Leave all required repair and
service jobs to an authorised service technician. He will exclusively use such spare parts that are complying with the same
safety standards as appliciable to the original parts. The use of
original spare parts can prevent fire, shock and other hazards.
Unplug the television receiver from the wall outlet and refer
servicing to qualified service personnel under the following
conditions:
■ If the power cord or plug is damaged.
■ If liquid has been spilt into the television
receiver.
■ If television receiver has been exposed to rain or water.
■ If the television receiver has been dropped or the cabinet has
been damaged.
■ If the television receiver exhibits a distinct change in performance.
■ If the television receiver does not operate normally by following
the operating instructions.
Adjust only those controls that are covered in the operating instructions as improper adjustment of other controls may result in damage.
This will often require extensive work by a qualified technician to
restore the television receiver to normal operation.
Servicing
Important:
This equipment is fitted with an approved non rewireable UK mains
plug. To change a fuse in this type of plug proceed as follows:
1. Remove the fuse cover and fuse.
2. Fit a new fuse which should be a BS1362 5Amp A.S.T.A. or BSI
approved type.
3. Ensure that the fuse cover is correctly refitted.
If the fuse cover is lost or damaged the plug must NOT be used but
replaced with a serviceable plug.
If the fitted plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place. If the mains plug
contains a fuse, this should have a rating of 5 Amp, ensure the fuse
cover is correctly fitted. If a plug without a fuse is used, the fuse at
the distribution board should not be greater than 5 Amp.
Note: The severed plug must be destroyed to avoid a possible
shock hazard should it be inserted into a 13Amp socket elsewhere.
The wires in this mains lead are coloured in accordance with the
following code:
Blue -------> Neutral
Brown ----> Live
1. The Blue wire must be connected to the terminal whichis
marked with the letter “N” or coloured BLACK.
2. The Brown wire must be connected to the terminal with the
letter “L” or coloured RED.
3. Do not connect either wire to the earth terminal in the symbol
or coloured GREEN or GREEN and YELLOW.
Before replacing the plug cover, make certain that the cord grip is
clamped over the sheath of the lead - not simply over the wires.
10cm
20cm
10cm
5cm
!
3
Connect your aerial cable into the back of the TV set.
Connect the power cord of the TV set to a wall outlet.
✐ The TV set is prepared for a mains voltage AC220~240V, 50Hz.
When the TV set is not to be used for an extended period of time,
it is advisable to disconnect the power cord from the power outlet.
✐ For all aerial problems please consult your local dealer.
● Connecting DVD / VCR player/ Satellite receiver
or Set top box.
We recommend that you connect all other equipment before Plug
and Play. The following example is our recommended standard
connection. For further information please consult your local dealer.
Please refer to individual Instruction Manuals for each piece of
equipment for their connection suggestions.
Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on
the batteries match the "+" and "-" marks inside the unit into the
remote control handset.
Press the
Mains on off switch on the front of the TV set.
This TV set provides a self- automatic
tuning function called Plug and Play which
automatically searches and stores all of
the available TV stations in your reception
area.
A welcome message will appear, once this has finished the following
screen appears.
To remove the completed message press the
5, 6or 1, 2
buttons.
Now the installation is complete!
After Plug & Play the TV set automatically allocates the following
major stations in the UK.
Position 1 : BBC1
Position 2 : BBC2
Position 3 : ITV
Position 4 : CH4 or S4C
Position 5 : CH5
Position 6 : SKY, BBC-World or BBC-Prime
✐
If any other channels are available in your reception area, the
remaining stations will be stored from programme position 7 in
sequence as found.
✐
If you move to another city or cable is installed, please follow the
description “TUNING”. (on page 6).
✐
This procedure only appears the first time you switch on.
5 or 6 increases or decreases the programme position.
1 or 2 increases or decreases the sound volume.
■ Front terminals
✐
To select the AV3 mode press the v button repeatedly.
✐
When the headphones are inserted the sound from the TV
speakers are muted.
INST
INST
ALLA
ALLA
TION
TION
Step : 1 Connections ( Essential)
Step : 2 Remote control battery installation
AC Mains Outlet
WARNING! High voltages are used in the operation of
this set. Refer service to qualified service personnel.
Step : 3 Switching on / Plug & Play
TV front controls / Terminals
AV2
TV
AV2
Option if no DVD
AV1
ANT.75Ω
AV1
ANT.75Ω
Thank you for purchasing your
SANYO TV.
Now I am searching and storing all
programmes. Please wait.
Auto set-up completed. Happy viewing!
01
P
VCR
Set top box
or
Satellite
VCR
TV
DISH
IN
OUT
IN
OUT
IN
For Satellite
only
DVD
Headphone
Jack
AV3 Video/ Audio-input Jacks
L/S R/D
From Camcorder
or video game
equipment
Camcorder
Game
equipment
Loading...