Sanyo CE28DN8-B Instruction Manual

CE21DN8-B

CE25DN8-B

CE28DN8-B

Please read this Instruction book before using your television.

We wish you many hours of pleasure from your new television.

Colour T elevision

INSTRUCTION MANUAL

Common specification

Power source AC 220~240V 50Hz

Television system System I

Colour system PAL/NTSC4.43

(PAL/NTSC4.43/NTSC3.58 in AV mode)

Channel coverage UHF: 21-69,

Aerial input impedance 75 ohm

AV terminal

AV1: CENELEC Standard

Input: Composite video, RGB and audio-L/R

Output: TV-output with composite video and

audio-L/R

AV2: CENELEC Standard

Input: Composite video, S-VHS and audio-L/R

Output: Monitor-output with composite video and

audio-L/R

Front AV terminal

AV3: RCA jacks

Input: Composite video and audio-L/R

CE21DN8-B CE25DN8-B CE28DN8-B

Sound output

(Continuous) 2 x 3W 2 x 3W 2 x 3W

Picture tubes

(inches) 21 25 28

Dimensions

(WxHxD mm)

612 x 476 x 482 680 x 543 x 442 736 x 597 x 494

Weight (kg) 21 26 32

TV Specifications

SAFETY PRECA

UTIONS

Do not allow anything to rest on the power cord. Do not locate

this television receiver where the cord will be damaged by

people walking on it.

Do not overload wall outlets and extension cords as this can

result in fire or electric shock.

Slots and openings in the cabinet and in the back or bottom are

provided for ventilation to ensure reliable operation and to protect

it from overheating.These openings

must not be blocked or

covered.The opening

should never be covered with a cloth or

other material, and the bottom openings

should not be blocked

by placing the television receiver on a bed, sofa, rug, or other

similar surface.This television receiver

should never be placed

near or over a radiator or heater.

Do not place your television receiver on an unstable stand, shelf

or table.Serious injur y to an individual, and damage to the

television may result if it should fall.Your sales person can

recommend approved stands or shelf and wall mounting

instructions.

This television receiver

should not be placed in a built-in

installation such as a bookcase unless proper ventilation is

provided.

If the television is built into a unit, or enclosed, the minimum

distances for ventilation must be maintained.Heat build up can

reduce the life of your television, and can be dangerous.

This television receiver should be operated only from the type of

power source indicated on the television or as indicated in the

Operating Instructions. If you are not sure of the type of power

supply in your home, consult your sales person or your local

power company.

Never add accessories that have not been specifically designed

for this television.

Do not drop or push objects into the

television cabinet slots or openings.Some

internal parts carr y hazardous voltages and

contact may result in an electric shock

hazard.

Never spill liquids of any kind on

the television receiver.

Do not place items

such as vases containing liquid on top of

the TV set.

Do not expose the television receiver to rain or use near water.

For example, near a bathtub, kitchen sink, in a wet basement,

etc. Before cleaning, unplug the television receiver from the wall

socket.

Never stand on, lean on or push the

television or its stand.

Never allow children

to play with the television or its stand.

Serious injury may result if it should fall.

Do not apply liquid cleaners or aerosol

cleaners directly onto the television receiv-

er.Use a damp cloth for cleaning.

Do not place candles or hot objects upon

the TV, next to it or behind it. Open flames

must never be used near the TV set.

MINIMUM

DISTANCES

10cm

20cm

10cm

Installation

Use

CAUTION: Please read and retain for your safety. This unit has been engineered and manufactured to assure your personal safety.

But improper use can result in potential electric shock or fire hazards. In order not to defeat the safeguards incorporated in this receiver

observe the following basic rules for its installation, use and servicing.

Your television is fully transistorised and does not contain any

user serviceable components.

You must not remove the rear cover of the TV by yourself.The

apparatus is working with high voltages and could damage

objects or even endanger people. Leave all required repair and

service jobs to an authorised service technician. He will exclu-

sively use such spare parts that are complying with the same

safety standards as appliciable to the original parts. The use of

original spare parts can prevent fire, shock and other hazards.

Unplug the television receiver from the wall outlet and refer

servicing to qualified service personnel under the following

conditions:

■ If the power cord or plug is damaged.

■ If liquid has been spilt into the television

receiver.

■ If television receiver has been exposed to rain or water.

■ If the television receiver has been dropped or the cabinet has

been damaged.

■ If the television receiver exhibits a distinct change in performance.

■ If the television receiver does not operate normally by following

the operating instructions.

Adjust only those controls that are covered in the operating instruc-

tions as improper adjustment of other controls may result in damage.

This will often require extensive work by a qualified technician to

restore the television receiver to normal operation.

Servicing

5cm

Important:

This equipment is fitted with an approved non rewireable UK mains

plug.To change a fuse in this type of plug proceed as follows:

1. Remove the fuse cover and fuse.

2. Fit a new fuse which should be a BS1362 5Amp A.S.T.A. or BSI

approved type.

3. Ensure that the fuse cover is correctly refitted.

If the fuse cover is lost or damaged the plug must NOT be used but

replaced with a serviceable plug.

If the fitted plug is not suitable for your socket outlets, it should be

cut off and an appropriate plug fitted in its place. If the mains plug

contains a fuse, this should have a rating of 5 Amp, ensure the fuse

cover is correctly fitted.If a plug without a fuse is used, the fuse at

the distribution board should not be greater than 5 Amp.

Note: The severed plug must be destroyed to avoid a possible

shock hazard should it be inserted into a 13Amp socket elsewhere.

The wires in this mains lead are coloured in accordance with the

following code:

Blue -------> Neutral

Brown ----> Live

1. The Blue wire must be connected to the terminal whichis

marked with the letter “N” or coloured BLACK.

2. The Brown wire must be connected to the terminal with the

letter “L” or coloured RED.

3. Do not connect either wire to the earth ter minal in the symbol

or coloured GREEN or GREEN and YELLOW.

Before replacing the plug cover, make cer tain that the cord grip is

clamped over the sheath of the lead - not simply over the wires.

Connect your aerial cable into the back of the TV set.

Connect the power cord of the TV set to a wall outlet.

✐ The TV set is prepared for a mains voltage AC220~240V, 50Hz.

When the TV set is not to be used for an extended period of time,

it is advisable to disconnect the power cord from the power outlet.

✐ For all aerial problems please consult your local dealer.

● Connecting DVD / VCR player/ Satellite receiver

or Set top box.

We recommend that you connect all other equipment before Plug

and Play. The following example is our recommended standard

connection. For fur ther information please consult your local dealer.

Please refer to individual Instruction Manuals for each piece of

equipment for their connection suggestions.

Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on

the batteries match the "+" and "-" marks inside the unit into the

remote control handset.

Press the

Mains on off switch on the front of the TV set.

This TV set provides a self- automatic

tuning function called Plug and Play which

automatically searches and stores all of

the available TV stations in your reception

area.

A welcome message will appear, once this has finished the following

screen appears.

To remove the completed message press the

5, 6or 1, 2

buttons.

Now the installation is complete!

After Plug & Play the TV set automatically allocates the following

major stations in the UK.

Position 1 :BBC1

Position 2 :BBC2

Position 3 :ITV

Position 4 :CH4 or S4C

Position 5 :CH5

Position 6 :SKY, BBC-World or BBC-Prime

✐

If any other channels are available in your reception area, the

remaining stations will be stored from programme position 7 in

sequence as found.

✐

If you move to another city or cable is installed, please follow the

description “TUNING”. (on page 6).

✐

This procedure only appears the first time you switch on.

5 or 6 increases or decreases the programme position.

1 or 2 increases or decreases the sound volume.

■ Front terminals

✐

To select the AV3 mode press the v button repeatedly.

✐

When the headphones are inserted the sound from the TV

speakers are muted.

INST

ALLA

TION

Step : 1 Connections ( Essential)

ANT.75Ω

AV1

AV2

Step : 2 Remote control battery installation

AC Mains Outlet

WARNING! High voltages are used in the operation of

this set. Refer service to qualified service personnel.

Auto set-up completed. Happy viewing!

Step : 3 Switching on / Plug & Play

Thank you for purchasing your

SANYO TV.

Now I am searching and storing all

programmes. Please wait.

ANT.75Ω

AV1

AV2

VCR

OUT

Set top box

Satellite

VCR

DVD

Option if no DVD

For Satellite

only

DISH

From Camcorder

or video game

equipment

Headphone

Jack

AV3 Video/ Audio-input Jacks

Camcorder

Game

equipment

TV front controls / Terminals

+ 5 hidden pages