Sanyo 710-00792-1, 1AA6P1P1756 User Manual
Please read all instructions below and install this system properly.
Please read "SAFETY PRECAUTIONS" and "IMPORTANT SAFETY INSTRUCTIONS" on
OWNER'S MANUAL to install and place this system.
This system is supplied in 3 packages and they need to be installed. Please make sure all the
parts are included. If any part is missing, or if you have questions, contact a sales dealer.
CAUTION
WHEN INSTALLING THIS SYSTEM, BE CAREFUL NOT TO DAMAGE THE PROJECTION
SCREEN. AND NEVER TOUCH THE SURFACE OF THE PROJECTION SCREEN AND
THE PROJECTION MIRROR DIRECTLY. THEY MAY EFFECT THE PROJECTION IMAGE
QUALITY.
BE CAREFUL NOT TO DROP ANY PART OR TOOL LIKE SCREW INTO THE SYSTEM. IF
IT SHOULD, CONTACT A SERVICE.
EXCEPT WHEN ADJUSTING THE PROJECTION MIRROR, NEVER TURN THE SYSTEM
ON UNTIL THE INSTALLATION IS FINISHED. IT MAY CAUSE ELECTRICAL SHOCK OR
FIRE HAZARD.
REQUEST A SALES DEALER FOR INST ALLATION
Rear Projection Display
Installation Manual
Install the system following steps.
1AA6P1P1756-- (M8EA)
1.
CHECK CONTENTS IN PACKAGES
2.
ASSEMBLE BOTTOM CABINET
3.
JOINT TOP AND BOTTOM CABINETS
4.
SETUP PROJECTION MIRROR
5.
ADJUST PROJECTION MIRROR
THIS SYSTEM MUST BE INST ALLED BY 2 OR MORE PEOPLE
6.
ASSEMBLE STORAGE SPACES
7.
LOCK CABINET
710-00792-1
1
CHECK CONTENTS IN PA CKAGES
This system is supplied in 3 packages. Make sure all the parts listed below (cabinets, Installation parts,
and accessories) are included in those packages.
Top Cabinet : Refer to the steps 3 to 6 for installation.
Center Panel ----------------------------------------- 1
Package 1
Package 2
Package 3
Bottom Cabinet : Refer to the steps 2, 6 and 7 for installation.
Installation Part
Owner's Manual ---------------------------------------1
Installation Manual (this brochure) --------------- *
AC Power Cord ---------------------------------------*
Wireless Remote Control Unit -------------------- 1
Wireless/Wired Remote Control Unit -----------1
Remote Control Cable ----------------------------- 1
Batteries for Remote Controls -------------------- 4
VGA Cable ------------------------------------------- 1
MAC/VGA Adapter ---------------------------------- 1
Mouse Cables (Serial, PS/2, ADB)--------------- *
The accessories marked (*) may not supplied or may be
differ in quantity in some models. Refer to the Owner's
Manual for details.
Accessories
Qty.
Glass Doors ------------------------------------------- 2
Compartment Shelves ----------------------------- 4
Shelves' Pins ----------------------------------------- 16
Installation Parts
Qty.
Package 1
Package 2
Package 3
u Actual packages may be differ from this figure in some models.
2
ASSEMBLE BOTTOM CABINET
Remove the 4 Joint Bolts on the Bottom Cabinet.
Keep these bolts for later use. They are necessary
for joint the Top and Bottom Cabinets.
Remove the 2 Cover Plates on the top of the
Bottom Cabinet. Keep the Cover Plates for later
use. Replace those plates, when the appliance
needs to be transported.
Install the Center Panel to the Bottom Cabinet. Be
sure to meet the Center Panel and the Bottom
Cabinet at the upper part first, and insert the 6 legs
of Center Panel to the holes of the Bottom Cabinet.
Be sure to set the Center Panel securely.
Remove Joint Bolts and Cover Plates
Install Center Panel
1
2
Cover Plates
(2 pcs)
Joint Bolts (4 pcs)
Center Panel
Meet the Center Panel and the Bottom
Cabinet at the upper part first and
push in the Panel securely.
LegHole
There are the 5 Protection Pads inside of the
Bottom Cabinet for protection against shock or
vibration. Remove the 4 Pads supporting at the
upper side of the Bottom Cabinet first. And then,
remove the pad(A) supporting at the lower side of
the projector. When removing the pad(A), pull
downward first and remove the pad.
Remove Protection Pads
3
CAUTION
WHEN REMOVING THE PROTECTION
PADS, BE CAREFUL NOT TO BROKE THE
WIRING INSIDE OF THE BOTTOM
CABINET.
BE SURE TO REMOVE ALL THE
PROTECTION PADS INSIDE OF THE
CABINET. AND BE CAREFUL NOT TO
LEAVE ANY PAD OR FRAGMENT IN THE
CABINET. IT MAY RESULT IN FIRE
HAZARDS.
Joint Bolts
(4 pcs)
Protection Pads (5 pcs)
The back side of
the Bottom Cabinet.
Pad(A)
Pull the pad(A) to
downward first and
remove the pad.
Projector
Loading...