Sanus Systems XAS1A User Manual

XAS1A

(6901-100148 <01>)

Thank you for choosing the Sanus Systems XAS1A. The XAS1A is designed to mount speakers on each side of a
VMDD26 VisionMount full motion TV mount. The XAS1A will support speakers weighing up to 11 kg (25 lbs.) each.

CAUTION

Do not use this product for any purpose not explicitly specied by Sanus Systems. Improper installation may
cause property damage or personal injury. If you do not understand these directions, or have doubts about
the safety of the installation, contact Sanus Systems Customer Service or call a qualied contractor. Sanus
Systems is not liable for damage or injury caused by incorrect mounting, assembly, or use.

WARNING

This product contains small items that could be a choking hazard if swallowed. Keep these items away
from young children!

Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 USA

Customer Service: 1-800-359-5520 • [e-mail] • www.sanus.com

1/4-20 x 2.0 in.

1/4-20 x 3/8-16 1/4-20 x 3/8-16

M4 x 35mm

1/4-20

1/4-20 Nyloc

1/4-20 x 0.5 in.

M4 x 16mm

1/4-20 x 0.75 in.

M4 M6 M6 M4 M6M4

1/4-20 x 1.5 in. 1/4-20 x 1.25 in.

Supplied Parts and Hardware

Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the item
to your dealer; contact Sanus Systems Customer Service. Never use damaged parts!

[01] x 2

[02] x 2

[05] x 4 [06] x 4

[03] x 4

[07] x 4 [08] x 4 [09] x 4 [10] x 4

[11] x 4 [12] x 4 [13] x 4 [14] x 4 [15] x 4

[04] x 4

[16] x 4 [17] x 4 [18] x 4 [19] x 4 [20] x 4

[22] x 4

[24] x 18[23] x 4

[21] x 4

[25] x 1

6901-100148 <01>

1: Preparation

1- 1: New Installations

If you have purchased a VMDD26 VisionMount™ Full Motion Mount, but have not installed it, begin by following the large
VMDD26 installation instructions. Replace Cross Tube Installation with Step 2: Cross Tube Installation of the XAS1A instructions.
When completed, refer back to this Instruction manual, starting at Step 3: Install Extension Tubes.

1- 2: Existing Installations

NOTE

All graphics in this section are generic and are only used to illustrate a procedure.

[25]

Disconnect all electrical connections
and release all cables from any cable tie
downs. Remove the safety bolt [A] as
shown.

[A]

Lift the TV and arm assembly [B] off
the wall plate [C] as shown Lean the
assembly against a wall or other vertical
surface.

HEAVY! You will need assistance with this step.

Using an Allen Key, loosen the eight vise
assemblies [D]. Remove the lower cross
tube [E]; then, remove the upper cross
tube [F] as shown.

[D]

[D]

[B]

[C]

[F]

[E]

6901-100148 <01>