Sanus Systems Sanus Platinum Video Furniture PFPL PFPL PFPL, PFPL Assembly Instructions Manual

Assembly Instructions

MODEL PFPL - Digital TV Stand

Congratulations and thank you for purchasing your new Sanus

Platinum Furniture Product. If you have any questions regarding

this or any other Sanus product, please contact our customer

service department at [phone], or www.sanus.com. It is

not necessary to contact the retailer with any questions or

problems, as parts can be sent directly to you

PLATINUM FURNITURE

BUS5305

BUS5305

We recommend that the unit is assembled on a soft surface

such as carpet. Please record your serial number in the space

provided below and retain this manual for future reference.

Serial No

Please follow these assembly instructions. This will save you

time, make assembly easier and prevent possible damage to

your new Digital TV Stand. Assistance may be required for

some assembly procedures. Correct assembly is your

responsibility.

This unit was manufactured using ISO 9000 certified systems.
For improvement purposes, design and specifications are subject to
change without notice.

Shelf Pin
P840048 x 8

Cam
P820015T x 8

Wooden dowel

P800201 x 8

Connector rod
P820016T x 8

P860121 x 1

P860015 x 8

P860035 x 6

Barrel nut
P840050 x 8

P816145 x 4

Cable Ducts
P840170 x 2

CAUTION

There ar e many small c om ponents us ed in the construction of this unit.

These loose it ems should be kept away from young children while

assembling your unit.

1. Fasten 8 Connector Rods into small holes in Top as shown.

x8

Insert wooden dowels into sides as shown.

1. Insert black Barrel Nuts intosmaller holes in Rails,ensuring slot in cap is aligned to intersecting hole.

2. Insert silver Cams into larger holes in Rails, ens uring that arrow on Cam points towards intersecting hole.

3. Press fit Rails to Top as shown.

Intersecting

hole

Important:

*When fitting the rails onto the top, ensure that the grooved
part of the rails are closest to the side edges of the top.

* The larger holes (cam holes) in the rails must always be

closest to the Top.