
Assembly Instructions for Platinum Furniture Model: PFFP Shelf & PFFP2 Shelf
Thank you for choosing a Sanus Systems Platinum Furniture Model: PFFP Shelf and PFFP2 Shelf.
WARNING: If you do not understand these directions, or have any doubts about the safety of the installation, please call a qualied
contractor or contact Sanus at 800.359.5520 or www.sanus.com. Check carefully to make sure that there are no missing or defective
parts. Our customer service representatives can quickly assist you with installation questions and missing or damaged parts. Replacement
parts for products purchased through authorized dealers will be shipped directly to you. Never use defective parts. Improper installation
may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specied by Sanus Systems. Sanus
Systems can not be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use. Please call Sanus
Systems before returning products to the point of purchase.
Required Tools: 3/16” Allen Key
Supplied Parts and Hardware: (All threaded fasteners are shown full size.)
Large Glass Shelf - A
Qty. 1
Glass Shelf Washer - B
M8 Allen Bolt - F
Qty. 2
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
Qty. 1
1/4 - 20 Allen Bolt - G
Qty. 2
Shelf Bracket - C
Qty. 1
M8 Washer - H
Qty. 2
Shelf Plate - D
Qty. 1
Spring Washer - I
Qty. 2
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 03.07.06 (100029)
Shelf Bracket Cap - E
Qty. 1
Plastic Washer - J
Qty. 2

Step 1: Remove Top Cap and Wall bracket from Pillar
NOTE: This Step is required only if you have already assembled your PFFP or PFFP2.
Remove the Top Cap from the Pillar as shown in Diagram 1A.
Loosen the two M8 Allen Bolts; then, slide the Wall bracket Assembly up and out of the Pillar as shown in Diagram 1B
Diagram 1A Diagram 1B
Wall Bracket
Assembly
Pillar
Top Cap
Pillar
M8 Allen
Bolt
Step 2: Remove Small Glass Shelf
NOTE: This Step is required only if you have already assembled your PFFP2.
Remove the Shelf Bracket Cap as shown in Diagram 2.
Loosen the two M8 Allen Bolts; then, slide the Small Glass Shelf up and out of the
Pillar as shown in Diagram 2
Step 3: Shelf Bracket assembly
Thread two M8 Allen Bolts (F) through a Spring Washer (I), a M8 Washer (H), the
Shelf Bracket (C), and into the Shelf Plate (D) as shown in Diagram 3.
Using the Allen Key, screw the two M8 Allen Bolts (F) into a Shelf Plate (D) until
there is a gap of 1/8” between the Shelf Bracket (D) and the Shelf Plate as shown
in Diagram 3.
Shelf Bracket
Cap
Small Glass
Shelf
H
I
F
Diagram 2
M8 Allen
Bolt
Pillar
Diagram 3
D
C