Sanus NFCFT, NFCKT, NFEDT User Manual

Natural Furniture Instructions

QC#

Step 1

Check to be sure that you have all parts listed below. If any parts are miss
ing or damaged, contact Sanus Customer Service at [phone] or
www.sanus.com.

NFCKT

-

NF203

NFCFT

PART NFCFT NFCKT NFEDT

Decorative Face Bolts a 24 12 12

Three Hole Plate b 8 4 4

Glass Protectors (pads of 4) c 2 1 1

Hex Key d 1 1 1

Glass Mid Shelves 1 1 1

Glass Top Shelf 1 1 1

Wood Frame 2 2 2

Steel Cross Tubes 12 6 6

Step 2

Push the Decorative Face Bolts into the front of the first Wood Frame. Seat
them by tapping them lightly with a rubber hammer or the handle of a screw
driver. They do not need to be tapped in all the way; this will happen in step

3. Lay the frame face down on a soft surface so that the threads of the Face
Bolts point up.

Step 3

Place a Three Hole Bracket over each set of 3 Decorative Face Bolts. Attach a
Steel Cross Tube to each Decorative Face Bolt on

one of the Frames. Tighten

the Tubes firmly by hand.

Step 1

Step 2

Step 3

a

c d

b

Step 4

Place Three Hole Brackets between each set of steel cross tubes and the frame
on this side as well. Attach the second Frame to the other end of the Tubes
and tighten carefully with the Hex Key.

Step 5

Install the Glass Mid Shelves. Clear rubber Glass Protector pads are included.
Place a Glass Protector on the top corner of each Wood Frame. Set the Top
Glass in place.

Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 11.19.04

Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com

Step 5