Sanus NF206 User Manual

Assembly Instructions for Natural Furniture: Model NF206

Thank you for choosing the Natural Furniture line from Sanus Systems. If you have any questions regarding this or any other Sanus Systems product, contact us at 800.359.5520 or visit us at www.sanus.com. Our customer service representatives will assist you with any issues regarding assembly or missing parts. Check to make sure none of the parts are missing or defective. Never use defective parts. Replacement parts for products purchased from an authorized dealer will be shipped directly to you. Please call Sanus Systems before returning products to retail stores.

Supplied Parts List: (Not to Scale)

Glass Top Shelf - C

Qty. 1

Cross Tube - E

Qty. 6

	Front Frame - A	Rear Frame - B
		Qty. 1
	Qty. 1

Wire Strap - I	Three Hole Plate - J
Qty. 2	Qty. 4	Plastic Wire Cover
		30 in - G
		Qty. 1

Glass Mid Shelf - D

Qty. 5

Cross Tube W/ Stud - F

Qty. 4

Plastic Wire Cover

21 in - H

Qty. 1

Sanus Systems 2221 Hwy 36 West. St. Paul, MN 55113

800.359.5520 www.sanus.com 05.12.06 (100038)

Supplied Hardware: (Full Size)

Allen Key - M

Qty. 1

	Allen Bolt - K	1 in. Washer - L
	Qty. 10
		Qty. 8

Glass Protector - P

Qty. 4

Decorative Face Bolt - N

Qty. 6 1.5 in. Washer - O

Qty. 6

Step 1: Attach Cross Tubes to Front Frame

NOTE: For ease of assembly, lay the Front Fame face down on a soft flat surface after inserting the six Decorative

Face Bolts.

Insert six Decorative Face Bolts (N) through the Front Frame (A). Slide a Three Hole Plate (J) over the Decorative Face Bolts; then, screw a Cross Tube (E) onto each Decorative Face Bolt, firmly hand tighten each Cross Tube.

Diagram 1

A E

J

N