Assembly Instructions for Model: AFM2 II
Thank you for choosing the Sanus Systems Model AFM2 II. Every effort has been made to ensure that your Sanus Systems furniture is perfect. If you have questions or feel that there is a problem of any kind, please contact us at 800-359-5520 or at www.sanus.com. We can quickly help with any issues regarding assembly or missing parts. Replacement parts for Sanus systems products purchased through authorized dealers will be shipped directly to you.
Supplied Parts List:
|
Small Screw - C |
Short Stud - D |
|
|
Qty. 2 |
||
Short Pillar - A |
Qty. 4 |
||
|
|||
|
|
||
Qty. 4 |
|
|
|
|
Long Stud - E |
Plastic Foot - F |
|
|
Qty. 4 |
||
|
Qty. 4 |
||
|
|
Speaker Platform - H
Qty. 1
Plastic CD Holder - G
Qty. 1
Long Pillar - B |
Equipment Platform - I |
|
Qty. 1 |
||
Qty. 4 |
||
|
NOTE: You will assemble this product upside down. The Equipment Platform has threaded metal inserts in its bottom. Lay the Equipment Platform face down on a soft surface with the threaded inserts facing up and the square edge facing away from you.
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 1.20.06 (100001)
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
Step 1 - Attach the Short pillars to the Equipment Platform
NOTE: The Short Studs have a long and short end.
Thread the short end of the Short Studs (D) into the inserts in the Equipment Platform (I) until snug.
Thread a Short Pillar (A) onto each Short Stud (D) and firmly hand tighten.
Diagram 1
A
D I
Step 2 - Attach the Plastic CD Holder to the Equipment Platform
Locate the small pilot holes in the Equipment platform (I); then, using the two Small Screws (C), attach the Plastic CD Holder (G) to the Equipment Platform.
Diagram 2
C
G
Slot
|
Front Edge |
|
|
NOTE:noteSlots in the Plastic CD |
|
|
Holder (G) must face toward |
|
I |
front or rounded edge of the |
|
Equipment Platform (I). |
||
|