Sanus EFSATW, EFSATS User Manual

Specialty Bracket Mounting Instructions

Sanus Systems makes every effort to provide a universal speaker stand. Bracket options are available for a variety of speakers. Some of these mounting options are for specific speakers and some of them can be used with multiple speakers. If you have any questions or concerns when mounting your speakers please contact Sanus Systems at 800.359.5520 or www.sanus.com.

Klipsch RS speakers

First attach the Klipsch RS brackets to the top of your speaker stand pillars using the flat head screws (g). Next, separate each speaker from itʼs ball and socket by removing the 4 small screws on the angled surface of the speaker. Use the allen key provided under the foot of the speaker. Finally line the two bottom holes on this angled surface up with the slots on the Klipsch RS bracket and reinsert two of the screws that were previously used to hold the foot in place.

Klipsch Quintet

First attach the Klipsch Quintet (EFKQ) brackets to the top of your speaker stand pillars using the flat head screws (g). Next line up the hole on the angled surface of the quintet speaker with the slot in the mounting bracket. Finally use the Phillips pan head screws (l) to attach the speaker to the bracket.

Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 11.19.04 Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com

Rear Bolt Lbracket

First attach the L brackets to the top of your speaker stand pillars using the flat head screws (g). Next place the correct speaker bolt through the L bracket, through the spacer, and thread it into the insert on the back of the speaker.

Infinity Modulus and Other Bottom

Bottom Bolt Mounting Speakers

First thread the Modulus nuts down onto the Modulus studs and thread these combinations down into the top of your speaker stand pillars. Next place a Modulus washer over each stud. Then separate each speaker from itʼs base. Refer to the speakers instructions for details on this process. Finally attach the speaker by spinning it onto the threaded stud. You may need to adjust the placement of the Modulus nut

OptionalAccessory Bracket EFB

Double Bolt mount

First attach the L brackets to the top of your speaker stand pillars using the flat head bolts (g). Next attach the optional EFB to the back of each speaker. Place a speaker bolt (n) through each appropriate slot in the EFB, through the spacer, and thread it into the back of the speaker. Once this bracket is attached it will slide down over the back of the L bracket.

Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 11.19.04 Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com