Sanus EFSATW, EFSATS User Manual

Specialty Bracket Mounting Instructions

Sanus Systems makes every effort to provide a universal speaker stand. Bracket options are available for a variety
of speakers. Some of these mounting options are for specific speakers and some of them can be used with multiple
speakers. If you have any questions or concerns when mounting your speakers please contact Sanus Systems at

800.359.5520 or www.sanus.com.

Klipsch RS speakers

First attach the Klipsch RS brackets
to the top of your speaker stand pil
lars using the flat head screws (g).
Next, separate each speaker from
itʼs ball and socket by removing
the 4 small screws on the angled
surface of the speaker. Use the allen
key provided under the foot of the
speaker. Finally line the two bottom
holes on this angled surface up with
the slots on the Klipsch RS bracket
and reinsert two of the screws that
were previously used to hold the
foot in place.

-

Klipsch Quintet

First attach the Klipsch Quintet
(EFKQ) brackets to the top of your
speaker stand pillars using the flat
head screws (g). Next line up the
hole on the angled surface of the
quintet speaker with the slot in the
mounting bracket. Finally use the
Phillips pan head screws (l) to attach
the speaker to the bracket.

Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 11.19.04

Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com

Rear Bolt L bracket

First attach the L brackets to the top of
your speaker stand pillars using the flat
head screws (g). Next place the correct
speaker bolt through the L bracket,
through the spacer, and thread it into
the insert on the back of the speaker.

Infinity Modulus and Other Bottom
Bottom Bolt Mounting Speakers

First thread the Modulus nuts down
onto the Modulus studs and thread
these combinations down into the top
of your speaker stand pillars. Next
place a Modulus washer over each
stud. Then separate each speaker from
itʼs base. Refer to the speakers instruc
tions for details on this process. Finally
attach the speaker by spinning it onto
the threaded stud. You may need to ad­just the placement of the Modulus nut

-

Optional Accessory Bracket EFB

Double Bolt mount

First attach the L brackets to the top
of your speaker stand pillars using the
flat head bolts (g). Next attach the op
tional EFB to the back of each speaker.
Place a speaker bolt (n) through each
appropriate slot in the EFB, through
the spacer, and thread it into the back
of the speaker. Once this bracket is at­tached it will slide down over the back
of the L bracket.

Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 11.19.04

Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com

-