Assembly Instructions for Model: CFA21
Thank you for choosing Sanus Systems Component Furniture. Please check carefully to make sure there are no missing or defective
parts. Never use defective parts. Improper assembly may cause damage or serious injury. If you have any questions regarding this product, contact Sanus at 800.359.5520 or visit www.sanus.com. Our customer service representatives can quickly assist you with missing or
damaged parts. Replacement parts for Sanus products purchased through authorized dealers can be shipped directly to you. Please call
Sanus Systems before returning products to the point of purchase.
REQUIRED TOOLS: Philips Screw Driver, Hammer
Check Carefully to ensure there are no missing Parts or Hardware before beginning the installation.
HARDWARE: (shown at actual size)
(4) Carpet Spike and Nut Assembly - a (8) Cam Pin - b (4) Dowel - c
(4) Back Panel Bolt - d (4) Spacer - e (4) Bottom Shelf Pin - f
(4) Shelf Pin - g (1) Knob Bolt - h (1) Knob - i
(4) Hinge Screw - j (4) Hinge Plate Screw - k (1) Allen Key - l
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 1.26.04
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
Parts: *Some parts not shown at same scale.
(4) Foot - m* (2) Hinge Plate - n* (2) Hinge - o*
(2) Front Rail - p (2) Back Rail - q
(2) Side Panel - r (1) Back Panel - s (1) Door - t
(1) Top - u (1) Glass Shelf - v
(1) Bottom Shelf - w
Step 1: Add feet
Add a Foot (m) to each pillar of each Side Panel Assembly (r) as shown in Diagram 1. If you wish to install the Carpet Spikes (a), thread
each Carpet Spike into the foot as seen in Diagram 1. You can adjust the height of the Carpet Spikes with the Nut shown in the Detailed
View of Diagram 1.
Warning: The ends of the carpet spikes are sharp and may scratch floors or furniture. All sharp objects can be hazardous to
children. For this reason we provide the carpet spikes as an option. Sanus Systems will not be liable for damage or injury.
Diagram 1 Detailed View
r
m
a
Step 2: Attach the Front Rails to the Side Panel Assembly
Attach the Front Rail (p) to the Side Panel Assembly (r) by sliding the clamp down the groove in the Side Panel pillar as shown in the
Top View A of Diagram 2. Make sure the flat smooth side of the Front Rail is facing outward and the smooth flat side up (so the open
channel faces down), as showin in Diagram 2. Once the Front Rail is positioned at the bottom of the groove and resting on the Foot (m),
tighten the allen bolt on the back side of the Front Rail so the clamp widens to hold the Front Rail firmly in place. Repeat process for the
other Front Rail, making sure it is level with the top of the corner pillar.
Top View A Diagram 2
(Front Left Corner)
r
allen bolt
p
clamp
Loading...